[PATCH v4 05/12] wifi: ath12k: scan statemachine changes for single wiphy

[Rameshkumar Sundaram]

On 3/13/2024 4:05 AM, Jeff Johnson wrote:
> On 3/12/2024 6:55 AM, Rameshkumar Sundaram wrote:
>> From: Sriram R <quic_srirrama at quicinc.com>
>>
>> When multiple radios are advertised as a single wiphy which
>> supports various bands, a default scan request to mac80211
>> from cfg80211 will split the driver request based on band,
>> so each request will have channels belonging to the same band.
>> With this supported by default, the ath12k driver on receiving
>> this request checks for one of the channels in the request and
>> selects the corresponding radio(ar) on which the scan is going
>> to be performed and creates a vdev on that radio.
>>
>> Note that on scan completion this vdev is not deleted. If a new
>> scan request is seen on that same vif for a different band the
>> vdev will be deleted and created on the new radio supporting the
>> request. The vdev delete logic is refactored to have this done
>> dynamically.
>>
>> The reason for not deleting the vdev on scan stop is to avoid
>> repeated delete-create sequence if the scan is on the same band.
>> Also, during channel assign, new vdev creation can be optimized
>> as well.
>>
>> Also if the scan is requested when the vdev is in started state,
>> no switching to new radio is allowed and scan on channels only
>> within same radio is allowed.
>>
>> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
>> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
>>
>> Signed-off-by: Sriram R <quic_srirrama at quicinc.com>
>> Signed-off-by: Rameshkumar Sundaram <quic_ramess at quicinc.com>
>> ---
> ...
>> +	/* If the vif is already assigned to a specific vdev of an ar,
>> +	 * check whether its already started, vdev which is started
>> +	 * are not allowed to switch to a new radio.
>> +	 * If the vdev is not started, but was earlier created on a
>> +	 * different ar, delete that vdev and create a new one. We don't
>> +	 * delete at the scan stop as an optimization to avoid reduntant
> 
> s/reduntant/redundant/
Sure will fix it in next version
> 
>> +	 * delete-create vdev's for the same ar, in case the request is
>> +	 * always on the same band for the vif
>> +	 */
>