[PATCH v4 05/12] wifi: ath12k: scan statemachine changes for single wiphy

[Jeff Johnson]

On 3/12/2024 6:55 AM, Rameshkumar Sundaram wrote:
> From: Sriram R <quic_srirrama at quicinc.com>
> 
> When multiple radios are advertised as a single wiphy which
> supports various bands, a default scan request to mac80211
> from cfg80211 will split the driver request based on band,
> so each request will have channels belonging to the same band.
> With this supported by default, the ath12k driver on receiving
> this request checks for one of the channels in the request and
> selects the corresponding radio(ar) on which the scan is going
> to be performed and creates a vdev on that radio.
> 
> Note that on scan completion this vdev is not deleted. If a new
> scan request is seen on that same vif for a different band the
> vdev will be deleted and created on the new radio supporting the
> request. The vdev delete logic is refactored to have this done
> dynamically.
> 
> The reason for not deleting the vdev on scan stop is to avoid
> repeated delete-create sequence if the scan is on the same band.
> Also, during channel assign, new vdev creation can be optimized
> as well.
> 
> Also if the scan is requested when the vdev is in started state,
> no switching to new radio is allowed and scan on channels only
> within same radio is allowed.
> 
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
> 
> Signed-off-by: Sriram R <quic_srirrama at quicinc.com>
> Signed-off-by: Rameshkumar Sundaram <quic_ramess at quicinc.com>
> ---
...
> +	/* If the vif is already assigned to a specific vdev of an ar,
> +	 * check whether its already started, vdev which is started
> +	 * are not allowed to switch to a new radio.
> +	 * If the vdev is not started, but was earlier created on a
> +	 * different ar, delete that vdev and create a new one. We don't
> +	 * delete at the scan stop as an optimization to avoid reduntant

s/reduntant/redundant/

> +	 * delete-create vdev's for the same ar, in case the request is
> +	 * always on the same band for the vif
> +	 */