[PATCH v3 13/13] wifi: ath12k: disable QMI PHY capability learn in split-phy QCN9274
Jeff Johnson
quic_jjohnson at quicinc.com
Wed Jan 31 13:08:14 PST 2024
On 1/28/2024 10:57 PM, Raj Kumar Bhagat wrote:
> QMI PHY capability learn is used to get PHY count information to
> support single/multi link operation (SLO/MLO) configuration. The
> QCN9274 dualmac firmware currently do not support SLO/MLO, if two
> PHYs are within the same chip. Due to this firmware crashes in
> split-phy QCN9274, while bringing up AP with MLO parameter enabled
> in QMI host capability request message.
>
> The QMI PHY capability learn is not required for split-phy QCN9274,
> if SLO/MLO is not supported within the same chip. Hence, disable QMI
> PHY capability learn support in split-phy QCN9274.
>
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.1.1-00188-QCAHKSWPL_SILICONZ-1
> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
>
> Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag at quicinc.com>
Acked-by: Jeff Johnson <quic_jjohnson at quicinc.com>
More information about the ath12k
mailing list