[PATCH v3 13/13] wifi: ath12k: disable QMI PHY capability learn in split-phy QCN9274

[Raj Kumar Bhagat]

On 1/30/2024 7:22 AM, Jeff Johnson wrote:
> On 1/28/2024 10:57 PM, Raj Kumar Bhagat wrote:
>> QMI PHY capability learn is used to get PHY count information to
>> support single/multi link operation (SLO/MLO) configuration. The
>> QCN9274 dualmac firmware currently do not support SLO/MLO, if two
>> PHYs are within the same chip. Due to this firmware crashes in
>> split-phy QCN9274, while bringing up AP with MLO parameter enabled
>> in QMI host capability request message.
> 
> Does this patch need a Fixes: tag?
> 

I do not think Fixes: tag is required, because Single-phy QCN9274 and
WCN7850 works fine. The issue is only with Split-phy QCN9274, and it not
yet part of upstream ath.git.

>>
>> The QMI PHY capability learn is not required for split-phy QCN9274,
>> if SLO/MLO is not supported within the same chip. Hence, disable QMI
>> PHY capability learn support in split-phy QCN9274.
>>
>> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.0.1-00029-QCAHKSWPL_SILICONZ-1
>> Tested-on: QCN9274 hw2.0 PCI WLAN.WBE.1.1.1-00188-QCAHKSWPL_SILICONZ-1
>> Tested-on: WCN7850 hw2.0 PCI WLAN.HMT.1.0.c5-00481-QCAHMTSWPL_V1.0_V2.0_SILICONZ-3
>>
>> Signed-off-by: Raj Kumar Bhagat <quic_rajkbhag at quicinc.com>
>> ---
>>  drivers/net/wireless/ath/ath12k/core.c | 1 +
>>  drivers/net/wireless/ath/ath12k/core.h | 5 +++++
>>  drivers/net/wireless/ath/ath12k/mhi.c  | 1 +
>>  drivers/net/wireless/ath/ath12k/qmi.c  | 3 +++
>>  4 files changed, 10 insertions(+)
>>
>> diff --git a/drivers/net/wireless/ath/ath12k/core.c b/drivers/net/wireless/ath/ath12k/core.c
>> index ca3777c684b3..0d4640ff8d6f 100644
>> --- a/drivers/net/wireless/ath/ath12k/core.c
>> +++ b/drivers/net/wireless/ath/ath12k/core.c
>> @@ -1218,6 +1218,7 @@ struct ath12k_base *ath12k_core_alloc(struct device *dev, size_t priv_size,
>>  	ab->dev = dev;
>>  	ab->hif.bus = bus;
>>  	ab->qmi.num_radios = U8_MAX;
>> +	ab->slo_capable = true;
>>  
>>  	return ab;
>>  
>> diff --git a/drivers/net/wireless/ath/ath12k/core.h b/drivers/net/wireless/ath/ath12k/core.h
>> index f0a319ea57c1..a984171e4a08 100644
>> --- a/drivers/net/wireless/ath/ath12k/core.h
>> +++ b/drivers/net/wireless/ath/ath12k/core.h
>> @@ -842,6 +842,11 @@ struct ath12k_base {
>>  
>>  	const struct hal_rx_ops *hal_rx_ops;
>>  
>> +	/* slo_capable denotes if the single/multi link operation
>> +	 * is supported within the same chip (SoC).
>> +	 */
>> +	bool slo_capable;
>> +
>>  	/* must be last */
>>  	u8 drv_priv[] __aligned(sizeof(void *));
>>  };
>> diff --git a/drivers/net/wireless/ath/ath12k/mhi.c b/drivers/net/wireless/ath/ath12k/mhi.c
>> index 50b9e44504f7..adb8c3ec1950 100644
>> --- a/drivers/net/wireless/ath/ath12k/mhi.c
>> +++ b/drivers/net/wireless/ath/ath12k/mhi.c
>> @@ -385,6 +385,7 @@ int ath12k_mhi_register(struct ath12k_pci *ab_pci)
>>  				   "failed to read board id\n");
>>  		} else if (board_id & OTP_VALID_DUALMAC_BOARD_ID_MASK) {
>>  			dualmac = true;
>> +			ab->slo_capable = false;
>>  			ath12k_dbg(ab, ATH12K_DBG_BOOT,
>>  				   "dualmac fw selected for board id: %x\n", board_id);
>>  		}
>> diff --git a/drivers/net/wireless/ath/ath12k/qmi.c b/drivers/net/wireless/ath/ath12k/qmi.c
>> index 0f0eaadc8418..92845ffff44a 100644
>> --- a/drivers/net/wireless/ath/ath12k/qmi.c
>> +++ b/drivers/net/wireless/ath/ath12k/qmi.c
>> @@ -2124,6 +2124,9 @@ static void ath12k_qmi_phy_cap_send(struct ath12k_base *ab)
>>  	struct qmi_txn txn;
>>  	int ret;
>>  
>> +	if (!ab->slo_capable)
>> +		goto out;
>> +
>>  	ret = qmi_txn_init(&ab->qmi.handle, &txn,
>>  			   qmi_wlanfw_phy_cap_resp_msg_v01_ei, &resp);
>>  	if (ret < 0)
>