[PATCH v4 0/4] ath11k: factory test mode support

[Kalle Valo]

<andrea.marcer at external.marelli.com> writes:

>> Device is booted in factory test mode to calibrate the board.
>> The commands are sent from a userspace application, which is
>> sent to firmware using wmi commands. Firmware will send the
>> response back to the application which stores the calibration
>> data in caldata.bin file. This file will be loaded when the
>> device boots up normally next time.
>
> I would like to calibrate and generate test signals on a QCN9074 
> chip using the factory test mode. Which userspace application 
> am I supposed to use to perform the calibration and tests?
>
> QCN9074 PCI WLAN.HK.2.5.0.1-03982-QCAHKSWPL_SILICONZ-3 
> Linux Kernel 6.1

To my knowledge there are no calibration tools publically available,
unfortunately.

-- 
https://patchwork.kernel.org/project/linux-wireless/list/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches