[PATCH v4 0/4] ath11k: factory test mode support

[andrea.marcer at external.marelli.com]

> Device is booted in factory test mode to calibrate the board.
> The commands are sent from a userspace application, which is
> sent to firmware using wmi commands. Firmware will send the
> response back to the application which stores the calibration
> data in caldata.bin file. This file will be loaded when the
> device boots up normally next time.

I would like to calibrate and generate test signals on a QCN9074 
chip using the factory test mode. Which userspace application 
am I supposed to use to perform the calibration and tests?

QCN9074 PCI WLAN.HK.2.5.0.1-03982-QCAHKSWPL_SILICONZ-3 
Linux Kernel 6.1