[PATCH 0/2] ath11k: factory test mode support

[Raj Kumar Bhagat]

On 3/13/2023 5:51 PM, Kalle Valo wrote:
> Raj Kumar Bhagat <quic_rajkbhag at quicinc.com> writes:
> 
>> Device is booted in factory test mode to calibrate the board.
>> The commands are sent from a userspace application, which is
>> sent to firmware using wmi commands. Firmware will send the
>> response back to the application which stores the calibration
>> data in caldata.bin file. This file will be loaded when the
>> device boots up normally next time.
>>
>> Govindaraj Saminathan (1):
>>   wifi: ath11k: factory test mode support
>>
>> Sowmiya Sree Elavalagan (1):
>>   wifi: ath11k: Allow ath11k to boot without caldata in ftm mode
> 
> While reviewing the patches I made quite a few style cleanup to patches
> (too many to list):
> 
> https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=4a5ca29c396ace5c46b208a8c15a3ba53eabaddd
> 
> https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=ba74c7478f5d15ce38e609b9ad4810db7511a3dd
> 
> I only compile tested them. Please use these as the baseline for v2.
> 
Hi Kalle,

Unable to get the baseline patch for v2 from the above link. Getting the
below error with the link:
Bad commit reference: 4a5ca29c396ace5c46b208a8c15a3ba53eabaddd