[PATCH 0/2] ath11k: factory test mode support

[Kalle Valo]

Raj Kumar Bhagat <quic_rajkbhag at quicinc.com> writes:

> Device is booted in factory test mode to calibrate the board.
> The commands are sent from a userspace application, which is
> sent to firmware using wmi commands. Firmware will send the
> response back to the application which stores the calibration
> data in caldata.bin file. This file will be loaded when the
> device boots up normally next time.
>
> Govindaraj Saminathan (1):
>   wifi: ath11k: factory test mode support
>
> Sowmiya Sree Elavalagan (1):
>   wifi: ath11k: Allow ath11k to boot without caldata in ftm mode

While reviewing the patches I made quite a few style cleanup to patches
(too many to list):

https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=4a5ca29c396ace5c46b208a8c15a3ba53eabaddd

https://git.kernel.org/pub/scm/linux/kernel/git/kvalo/ath.git/commit/?h=master-pending&id=ba74c7478f5d15ce38e609b9ad4810db7511a3dd

I only compile tested them. Please use these as the baseline for v2.

-- 
https://patchwork.kernel.org/project/linux-wireless/list/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches