[PATCH v2] wifi: ath11k: Trigger sta disconnect on hardware restart

[Youghandhar Chintala (Temp)]

On 11/4/2022 4:17 PM, Kalle Valo wrote:
> Youghandhar Chintala <quic_youghand at quicinc.com> wrote:
>
>> Currently after the hardware restart triggered from the driver, the
>> station interface connection remains intact, since a disconnect trigger
>> is not sent to userspace. This can lead to a problem in targets where
>> the wifi mac sequence is added by the firmware.
>>
>> After the target restart, its wifi mac sequence number gets reset to
>> zero. Hence AP to which our device is connected will receive frames with
>> a  wifi mac sequence number jump to the past, thereby resulting in the
>> AP dropping all these frames, until the frame arrives with a wifi mac
>> sequence number which AP was expecting.
>>
>> To avoid such frame drops, its better to trigger a station disconnect
>> upon target hardware restart which can be done with API
>> ieee80211_reconfig_disconnect exposed to mac80211.
>>
>> The other targets are not affected by this change, since the hardware
>> params flag is not set.
>>
>> Reported-by: kernel test robot <lkp at intel.com>
>>
>> Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00887-QCAMSLSWPLZ-1
>>
>> Signed-off-by: Youghandhar Chintala <quic_youghand at quicinc.com>
>> Signed-off-by: Kalle Valo <quic_kvalo at quicinc.com>
> This had a new warning:
>
> drivers/net/wireless/ath/ath11k/mac.c:8056: Blank lines aren't necessary before a close brace '}'
>
> I fixed it in the pending branch.

Thank you Kalle.

Regards,

Youghandhar