[PATCH v2] wifi: ath11k: Trigger sta disconnect on hardware restart

[Kalle Valo]

Youghandhar Chintala <quic_youghand at quicinc.com> wrote:

> Currently after the hardware restart triggered from the driver, the
> station interface connection remains intact, since a disconnect trigger
> is not sent to userspace. This can lead to a problem in targets where
> the wifi mac sequence is added by the firmware.
> 
> After the target restart, its wifi mac sequence number gets reset to
> zero. Hence AP to which our device is connected will receive frames with
> a  wifi mac sequence number jump to the past, thereby resulting in the
> AP dropping all these frames, until the frame arrives with a wifi mac
> sequence number which AP was expecting.
> 
> To avoid such frame drops, its better to trigger a station disconnect
> upon target hardware restart which can be done with API
> ieee80211_reconfig_disconnect exposed to mac80211.
> 
> The other targets are not affected by this change, since the hardware
> params flag is not set.
> 
> Reported-by: kernel test robot <lkp at intel.com>
> 
> Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00887-QCAMSLSWPLZ-1
> 
> Signed-off-by: Youghandhar Chintala <quic_youghand at quicinc.com>
> Signed-off-by: Kalle Valo <quic_kvalo at quicinc.com>

This had a new warning:

drivers/net/wireless/ath/ath11k/mac.c:8056: Blank lines aren't necessary before a close brace '}'

I fixed it in the pending branch.

-- 
https://patchwork.kernel.org/project/linux-wireless/patch/20221104085403.11025-1-quic_youghand@quicinc.com/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches