[PATCH v4 02/12] ath11k: Add HW params for WCN6750
Kalle Valo
kvalo at kernel.org
Tue Apr 26 22:21:56 PDT 2022
Manikanta Pubbisetty <quic_mpubbise at quicinc.com> writes:
> Add HW params for WCN6750. It is similar to the HW params
> of QCA6390 with few differences wrt DP APIs and register
> offsets.
>
> Tested-on: WCN6750 hw1.0 AHB WLAN.MSL.1.0.1-00573-QCAMSLSWPLZ-1
> Tested-on: WCN6855 hw2.0 PCI WLAN.HSP.1.1-01720.1-QCAHSPSWPL_V1_V2_SILICONZ_LITE-1
> Tested-on: QCN9074 hw1.0 PCI WLAN.HK.2.5.0.1-01100-QCAHKSWPL_SILICONZ-1
> Tested-on: IPQ8074 hw2.0 AHB WLAN.HK.2.4.0.1-00192-QCAHKSWPL_SILICONZ-1
>
> Signed-off-by: Manikanta Pubbisetty <quic_mpubbise at quicinc.com>
> ---
> drivers/net/wireless/ath/ath11k/core.c | 61 ++++++++++++++++++++++++++
> drivers/net/wireless/ath/ath11k/core.h | 1 +
> drivers/net/wireless/ath/ath11k/qmi.h | 2 +
> 3 files changed, 64 insertions(+)
>
> diff --git a/drivers/net/wireless/ath/ath11k/core.c b/drivers/net/wireless/ath/ath11k/core.c
> index cbac1919867f..8695f999acb2 100644
> --- a/drivers/net/wireless/ath/ath11k/core.c
> +++ b/drivers/net/wireless/ath/ath11k/core.c
> @@ -427,6 +427,67 @@ static const struct ath11k_hw_params ath11k_hw_params[] = {
> .dbr_debug_support = false,
> .global_reset = true,
> },
> + {
> + .name = "wcn6750 hw1.0",
> + .hw_rev = ATH11K_HW_WCN6750_HW10,
> + .fw = {
> + .dir = "WCN6750/hw1.0",
> + .board_size = 256 * 1024,
> + .cal_offset = 128 * 1024,
> + },
> + .max_radios = 1,
> + .bdf_addr = 0x4B0C0000,
> + .ring_mask = &ath11k_hw_ring_mask_qca6390,
> + .internal_sleep_clock = false,
> + .qmi_service_ins_id = ATH11K_QMI_WLFW_SERVICE_INS_ID_V01_WCN6750,
> + .host_ce_config = ath11k_host_ce_config_qca6390,
> + .ce_count = 9,
> + .target_ce_config = ath11k_target_ce_config_wlan_qca6390,
> + .target_ce_count = 9,
> + .svc_to_ce_map = ath11k_target_service_to_ce_map_wlan_qca6390,
> + .svc_to_ce_map_len = 14,
> + .rfkill_pin = 0,
> + .rfkill_cfg = 0,
> + .rfkill_on_level = 0,
> + .single_pdev_only = true,
> + .rxdma1_enable = false,
> + .num_rxmda_per_pdev = 1,
> + .rx_mac_buf_ring = true,
> + .vdev_start_delay = true,
> + .htt_peer_map_v2 = false,
> +
> + .spectral = {
> + .fft_sz = 0,
> + .fft_pad_sz = 0,
> + .summary_pad_sz = 0,
> + .fft_hdr_len = 0,
> + .max_fft_bins = 0,
> + },
> +
> + .interface_modes = BIT(NL80211_IFTYPE_STATION) |
> + BIT(NL80211_IFTYPE_AP),
> + .supports_monitor = false,
> + .supports_shadow_regs = true,
> + .idle_ps = true,
> + .supports_sta_ps = true,
> + .cold_boot_calib = false,
> + .fw_mem_mode = 0,
> + .num_vdevs = 16 + 1,
> + .num_peers = 512,
> + .supports_suspend = false,
> + .supports_regdb = true,
> + .fix_l1ss = false,
> + .credit_flow = true,
> + .max_tx_ring = DP_TCL_NUM_RING_MAX_QCA6390,
> + .hal_params = &ath11k_hw_hal_params_qca6390,
> + .supports_dynamic_smps_6ghz = false,
> + .alloc_cacheable_memory = false,
> + .supports_rssi_stats = true,
> + .fw_wmi_diag_event = false,
> + .current_cc_support = true,
> + .dbr_debug_support = false,
> + .global_reset = false,
> + },
In the pending branch I added:
+ .bios_sar_capa = NULL,
--
https://patchwork.kernel.org/project/linux-wireless/list/
https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches
More information about the ath11k
mailing list