[PATCH] ath11k: add hw_param for wakeup_mhi

[Kalle Valo]

"Seevalamuthu Mariappan (Temp) (QUIC)" <quic_seevalam at quicinc.com>
writes:

>> Seevalamuthu Mariappan <quic_seevalam at quicinc.com> writes:
>> 
>> > Wakeup mhi is needed before pci_read/write only for QCA6390 and
>> > WCN6855. Since wakeup & release mhi is enabled for all hardwares,
>> > below mhi assert is seen in QCN9074.
>> >
>> > 	Kernel panic - not syncing: dev_wake != 0
>> > 	CPU: 2 PID: 13535 Comm: procd Not tainted 4.4.60 #1
>> > 	Hardware name: Generic DT based system
>> > 	[<80316dac>] (unwind_backtrace) from [<80313700>]
>> (show_stack+0x10/0x14)
>> > 	[<80313700>] (show_stack) from [<805135dc>]
>> (dump_stack+0x7c/0x9c)
>> > 	[<805135dc>] (dump_stack) from [<8032136c>] (panic+0x84/0x1f8)
>> > 	[<8032136c>] (panic) from [<80549b24>]
>> (mhi_pm_disable_transition+0x3b8/0x5b8)
>> > 	[<80549b24>] (mhi_pm_disable_transition) from [<80549ddc>]
>> (mhi_power_down+0xb8/0x100)
>> > 	[<80549ddc>] (mhi_power_down) from [<7f5242b0>]
>> (ath11k_mhi_op_status_cb+0x284/0x3ac [ath11k_pci])
>> > 	[E][__mhi_device_get_sync] Did not enter M0 state, cur_state:RESET
>> pm_state:SHUTDOWN Process
>> > 	[E][__mhi_device_get_sync] Did not enter M0 state, cur_state:RESET
>> pm_state:SHUTDOWN Process
>> > 	[E][__mhi_device_get_sync] Did not enter M0 state, cur_state:RESET
>> pm_state:SHUTDOWN Process
>> > 	[<7f5242b0>] (ath11k_mhi_op_status_cb [ath11k_pci]) from
>> [<7f524878>] (ath11k_mhi_stop+0x10/0x20 [ath11k_pci])
>> > 	[<7f524878>] (ath11k_mhi_stop [ath11k_pci]) from [<7f525b94>]
>> (ath11k_pci_power_down+0x54/0x90 [ath11k_pci])
>> > 	[<7f525b94>] (ath11k_pci_power_down [ath11k_pci]) from
>> [<8056b2a8>] (pci_device_shutdown+0x30/0x44)
>> > 	[<8056b2a8>] (pci_device_shutdown) from [<805cfa0c>]
>> (device_shutdown+0x124/0x174)
>> > 	[<805cfa0c>] (device_shutdown) from [<8033aaa4>]
>> (kernel_restart+0xc/0x50)
>> > 	[<8033aaa4>] (kernel_restart) from [<8033ada8>]
>> (SyS_reboot+0x178/0x1ec)
>> > 	[<8033ada8>] (SyS_reboot) from [<80301b80>]
>> > (ret_fast_syscall+0x0/0x34)
>> >
>> > Hence, disable wakeup/release mhi using hw_param for other hardwares.
>> >
>> > Tested-on: QCN9074 hw1.0 PCI
>> > WLAN.HK.2.5.0.1-01060-QCAHKSWPL_SILICONZ-1
>> >
>> > Fixes: a05bd85133 ("ath11k: read and write registers below unwindowed
>> > address")
>> > Signed-off-by: Seevalamuthu Mariappan <quic_seevalam at quicinc.com>
>> 
>> The commit log is not quite clear, are you saying that commit a05bd85133
>> broke QCN9074 support altogether? Or it was failing only in some cases?
>> I can update the commit log.
>> 
>
> [seevalam]: MHI assert seen during 'rmmod ath11k_pci' for QCN9074.

Thanks, I added that to the commit log.

-- 
https://patchwork.kernel.org/project/linux-wireless/list/

https://wireless.wiki.kernel.org/en/developers/documentation/submittingpatches