[PATCH 1/2] dt: bindings: add new dt entry for ath10k calibration variant

[Sven Eckelmann]

On Dienstag, 21. März 2017 21:56:54 CET Rob Herring wrote:
[...]
> Is this always the case? There's never some variation beyond the
> reference design that a BDF difference can't handle?

I have no knowledge about anything which isn't handled directly by the BDF
variants. But maybe Kalle can correct me here.

[...]
> > They are basically "qcom,ipq4019-wifi" + a product specific string. The first
> > part is therefore the string which identifies the wifi device(s) in the
> > QCA4018/4019 SoC. The product specific string is simply the part (or a
> > variation of it) which would been used before in
> > "qcom,ath10k-calibration-variant" - just to make it "use a more specific
> > compatible string".
> 
> It would probably be more like: "asus,rt-ac58u-wifi", "qcom,ipq4019-wifi"
> 
> A more specific compatible is insurance that at some later point in
> time you can distinguish between 2 boards due to some difference even
> if now you believe they are "the same".
[...]
> I think the separate property is fine if this is the only one you
> envision needing to add. If there's 10 more properties, then I'd feel
> more strongly towards a board specific compatible string.

Thank you. Let's wait a little bit in case someone from QCA/Codeaurora
has some additional input.

But your comments were really helpful.

Kind regards,
	Sven
-------------- next part --------------
A non-text attachment was scrubbed...
Name: signature.asc
Type: application/pgp-signature
Size: 833 bytes
Desc: This is a digitally signed message part.
URL: <http://lists.infradead.org/pipermail/ath10k/attachments/20170322/38627eb3/attachment.sig>