[RFC v3 0/8] ath10k sdio support

[Valo, Kalle]

Kalle Valo <kvalo at qca.qualcomm.com> writes:

> Erik Stromdahl <erik.stromdahl at gmail.com> writes:
>
>> I was actually about to email you about this.
>>
>> I have made a few more updates to the sdio code so I think it would be
>> best if I could submit a new series of patches based on this code (v4).
>>
>> Then you can tweak it (v5).
>>
>> It is only minor updates to the HIF layer (added QCA9377 support) and
>> a setup of some pll registers.
>
> Ok, that sounds good. I'll wait for v4.

Forgot to mention can you run ath10k-check before submitting them, it
shows few problems:

https://wireless.wiki.kernel.org/en/users/drivers/ath10k/codingstyle#checking_code

But if you wonder what this is about it's checkpatch warning about camel
case (doesn't like the lower case x character):

drivers/net/wireless/ath/ath10k/sdio.h:68: <ATH10K_SDIO_DRIVE_DTSx_TYPE_C>

I guess I have a bug in the script when it parses checkpatch output.

-- 
Kalle Valo