[RFC v3 0/8] ath10k sdio support

[Valo, Kalle]

Erik Stromdahl <erik.stromdahl at gmail.com> writes:

> I was actually about to email you about this.
>
> I have made a few more updates to the sdio code so I think it would be
> best if I could submit a new series of patches based on this code (v4).
>
> Then you can tweak it (v5).
>
> It is only minor updates to the HIF layer (added QCA9377 support) and
> a setup of some pll registers.

Ok, that sounds good. I'll wait for v4.

> btw, should I still mark them as RFC or should it be PATCH this time?
>
> If I go for PATCH, should the version be v4 or should I start from v1?

v4 would be fine. Thanks.

-- 
Kalle Valo