[PATCH 0/3] Core changes for wcn3990

[Rakesh Pillai]

Hi Kalle,

I have rebased the patchset on the latest ath.git and sent v2 for the change.

Thanks,
Rakesh Pillai

> -----Original Message-----
> From: Kalle Valo
> Sent: Thursday, December 21, 2017 7:27 PM
> To: Rakesh Pillai <pillair at qti.qualcomm.com>
> Cc: ath10k at lists.infradead.org; linux-wireless at vger.kernel.org
> Subject: Re: [PATCH 0/3] Core changes for wcn3990
> 
> Rakesh Pillai <pillair at qti.qualcomm.com> writes:
> 
> > This patchset includes the core changes for wcn3990 to
> > - Add SNOC bus type used for wcn3990 target
> > - Add the debug mask for SNOC bus type
> > - Adding fw feature flag for non-bmi firmware load, since wcn3990
> >   firmware is not loaded by bmi
> >
> > Govind Singh (2):
> >   ath10k: Add SNOC bus type for WCN3990 target
> >   ath10k: Add debug mask for SNOC bus type
> >
> > Rakesh Pillai (1):
> >   ath10k: Add fw feature flag for non-bmi firmware load
> 
> What did you use as the baseline for these patches? While I was trying
> to get these to the pending branch for build testing I noticed they
> don't apply to any of ath.git branches and git can't even find the
> baseline sha1 information:
> 
> $ git am -s -3 10127467.mbox
> Applying: ath10k: Add SNOC bus type for WCN3990 target
> Applying: ath10k: Add debug mask for SNOC bus type
> Applying: ath10k: Add fw feature flag for non-bmi firmware load
> fatal: sha1 information is lacking or useless
> (drivers/net/wireless/ath/ath10k/core.c).
> error: could not build fake ancestor
> Patch failed at 0003 ath10k: Add fw feature flag for non-bmi firmware load
> The copy of the patch that failed is found in: .git/rebase-apply/patch
> When you have resolved this problem, run "git am --continue".
> If you prefer to skip this patch, run "git am --skip" instead.
> To restore the original branch and stop patching, run "git am --abort".
> 
> --
> Kalle Valo