[PATCH 0/3] Core changes for wcn3990

[Kalle Valo]

Rakesh Pillai <pillair at qti.qualcomm.com> writes:

> This patchset includes the core changes for wcn3990 to
> - Add SNOC bus type used for wcn3990 target
> - Add the debug mask for SNOC bus type
> - Adding fw feature flag for non-bmi firmware load, since wcn3990
>   firmware is not loaded by bmi
>
> Govind Singh (2):
>   ath10k: Add SNOC bus type for WCN3990 target
>   ath10k: Add debug mask for SNOC bus type
>
> Rakesh Pillai (1):
>   ath10k: Add fw feature flag for non-bmi firmware load

What did you use as the baseline for these patches? While I was trying
to get these to the pending branch for build testing I noticed they
don't apply to any of ath.git branches and git can't even find the
baseline sha1 information:

$ git am -s -3 10127467.mbox
Applying: ath10k: Add SNOC bus type for WCN3990 target
Applying: ath10k: Add debug mask for SNOC bus type
Applying: ath10k: Add fw feature flag for non-bmi firmware load
fatal: sha1 information is lacking or useless (drivers/net/wireless/ath/ath10k/core.c).
error: could not build fake ancestor
Patch failed at 0003 ath10k: Add fw feature flag for non-bmi firmware load
The copy of the patch that failed is found in: .git/rebase-apply/patch
When you have resolved this problem, run "git am --continue".
If you prefer to skip this patch, run "git am --skip" instead.
To restore the original branch and stop patching, run "git am --abort".

-- 
Kalle Valo