how to configure MIMO

[Sebastian Gottschall]

Am 11.10.2016 um 12:11 schrieb Gyselinck Luc:
> Hi,
> I am using ath10k firmware for a couple of chipsets : QCA9984 (having 4x4 MIMO capabilities) and QCA9880 (with 3x3 MIMO capabilities).
> Is there a way to configure these chipsets only use a reduced MIMO capability ? E.g. Can I apply a configuration so that the QCA9984 is using only 3x3 MIMO?
basicly you're able to configure the used tx and rx antenna chains. so 
you can run it with 3x3 and for sure you can also configure the ht / vht 
capabilities in hostapd to run it with reduced capabilities

Sebastian
> If yes can you tell me how to do so?
>
> Thanks and best regards
> Luc
>
>
> _______________________________________________
> ath10k mailing list
> ath10k at lists.infradead.org
> http://lists.infradead.org/mailman/listinfo/ath10k
>


-- 
Mit freundlichen Grüssen / Regards

Sebastian Gottschall / CTO

NewMedia-NET GmbH - DD-WRT
Firmensitz:  Berliner Ring 101, 64625 Bensheim
Registergericht: Amtsgericht Darmstadt, HRB 25473
Geschäftsführer: Peter Steinhäuser, Christian Scheele
http://www.dd-wrt.com
email: s.gottschall at dd-wrt.com
Tel.: +496251-582650 / Fax: +496251-5826565