how to configure MIMO

Gyselinck Luc Luc.Gyselinck at technicolor.com
Tue Oct 11 03:11:05 PDT 2016

Previous message (by thread): QCA988x:ath10K in STA mode: Probe_Req() frame is NOT sent over the air, when the device is NOT set to scan_mode
Next message (by thread): how to configure MIMO
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

Hi,
I am using ath10k firmware for a couple of chipsets : QCA9984 (having 4x4 MIMO capabilities) and QCA9880 (with 3x3 MIMO capabilities).
Is there a way to configure these chipsets only use a reduced MIMO capability ? E.g. Can I apply a configuration so that the QCA9984 is using only 3x3 MIMO?
If yes can you tell me how to do so?

Thanks and best regards
Luc

Previous message (by thread): QCA988x:ath10K in STA mode: Probe_Req() frame is NOT sent over the air, when the device is NOT set to scan_mode
Next message (by thread): how to configure MIMO
Messages sorted by: [ date ] [ thread ] [ subject ] [ author ]

More information about the ath10k mailing list