QCA6164 in Fedora

[Susi Lehtola]

On 09/21/2015 12:18 AM, Michal Kazior wrote:
> On 10 September 2015 at 03:24, Susi Lehtola
> <jussilehtola at fedoraproject.org> wrote:
>> On 09/09/2015 05:48 PM, Susi Lehtola wrote:
>>>
>>> I can confirm the card works with the linux-next tree, using a snapshot
>>> I took today.
>>
>>
>> However, the card only seems to make a 1Mbps connection in the same
>> situation where my old laptop made a 55Mbps one...
>
> How did you measure this? `iw` tool reports invalid tx bitrate for
> ath10k due to firmware limitation. Did you test the actual performance
> (iperf/wget)? Is it downlink or uplink? Are both as bad?

This was the link speed reported by NetworkManager. But yes, actual 
performance is much better, seeing 2.2 MB/sec is not uncommon [the 
internet connection is pretty slow].
-- 
Susi Lehtola
Fedora Project Contributor
jussilehtola at fedoraproject.org