[PATCH v2 00/10] introduce wmi support for qca99X0
Kalle Valo
kvalo at qca.qualcomm.com
Tue Jun 30 05:32:18 PDT 2015
Raja Mani <rmani at qti.qualcomm.com> writes:
> qca99X0 uses 10.4 firmware. This patch series adds 10.4 firmware
> specific WMI cmds/events/parsing logic. All these patches tested
> on top of qca99X0 initial bring up patches.
>
> v2 changes:
> - Synced wmi service/cmd/event/pdev/vdev ids to most
> stable 10.4 firmware.
>
> Raja Mani (10):
> ath10k: include new wmi op version for 10.4 fw
> ath10k: add 10.4 fw wmi service bitmap definition
> ath10k: include 10.4 fw specific wmi cmd and event ids
> ath10k: set 10.4 fw exclusive wmi cmd as unsupported for other fw
> versions
> ath10k: add 10.4 fw wmi vdev cmd ids
> ath10k: add 10.4 fw wmi pdev cmd ids
> ath10k: fill 10.4 fw wmi init cmd default values
> ath10k: handle 10.4 fw wmi mgmt rx event
> ath10k: adjust default peer limits if qcache enabled in 10.4 fw
> ath10k: handle 10.4 fw wmi ready event
Thanks, applied.
--
Kalle Valo
More information about the ath10k
mailing list