[PATCH v2 3/8] ath10k: fix name of target_ps module parameter

Kalle Valo kvalo at qca.qualcomm.com
Fri Mar 28 03:32:33 EDT 2014


The parameter name was ath10k_target_ps, but actually it should be just
target_ps. Module parameter names should not use the ath10k_ prefix.

Signed-off-by: Kalle Valo <kvalo at qca.qualcomm.com>
---
 drivers/net/wireless/ath/ath10k/pci.c |    8 ++++----
 1 file changed, 4 insertions(+), 4 deletions(-)

diff --git a/drivers/net/wireless/ath/ath10k/pci.c b/drivers/net/wireless/ath/ath10k/pci.c
index 9dab859ed77b..670e6734a46b 100644
--- a/drivers/net/wireless/ath/ath10k/pci.c
+++ b/drivers/net/wireless/ath/ath10k/pci.c
@@ -44,12 +44,12 @@ enum ath10k_pci_reset_mode {
 	ATH10K_PCI_RESET_WARM_ONLY = 1,
 };
 
-static unsigned int ath10k_target_ps;
+static unsigned int ath10k_pci_target_ps;
 static unsigned int ath10k_pci_irq_mode = ATH10K_PCI_IRQ_AUTO;
 static unsigned int ath10k_pci_reset_mode = ATH10K_PCI_RESET_AUTO;
 
-module_param(ath10k_target_ps, uint, 0644);
-MODULE_PARM_DESC(ath10k_target_ps, "Enable ath10k Target (SoC) PS option");
+module_param_named(target_ps, ath10k_pci_target_ps, uint, 0644);
+MODULE_PARM_DESC(target_ps, "Enable ath10k Target (SoC) PS option");
 
 module_param_named(irq_mode, ath10k_pci_irq_mode, uint, 0644);
 MODULE_PARM_DESC(irq_mode, "0: auto, 1: legacy, 2: msi (default: 0)");
@@ -2531,7 +2531,7 @@ static int ath10k_pci_probe(struct pci_dev *pdev,
 		goto err_ar_pci;
 	}
 
-	if (ath10k_target_ps)
+	if (ath10k_pci_target_ps)
 		set_bit(ATH10K_PCI_FEATURE_SOC_POWER_SAVE, ar_pci->features);
 
 	ath10k_pci_dump_features(ar_pci);




More information about the ath10k mailing list