Only Lowest Legacy Rate 6Mbps used by Adhoc Mode

[Yeoh Chun-Yeow]

Hi, all

I have observed that only minimum legacy rate 6Mbps used by two nodes
setting up in adhoc mode.

Currently, there is no implementation on
IEEE80211_RC_SUPP_RATES_CHANGED. So I just disassociate, delete,
create and associate node back in HT mode as printed below, but no
luck the TxRate is stuck at 6Mbps

[  339.550000] ath10k: mac vdev 0 peer create 04:f0:21:0c:a5:1c (new
sta) num_peers 2
[  339.550000] ath10k: wmi peer create vdev_id 0 peer_addr 04:f0:21:0c:a5:1c
[  339.550000] ath10k: mac sta 04:f0:21:0c:a5:1c associated
[  339.550000] ath10k: mac peer 04:f0:21:0c:a5:1c phymode 11a
[  339.550000] ath10k: wmi peer assoc vdev 0 addr 04:f0:21:0c:a5:1c
[  339.550000] ath10k: mac sta rc update for 04:f0:21:0c:a5:1c changed
00000004 bw 0 nss 1 smps 2
[  339.550000] ath10k: mac sta rc update for 04:f0:21:0c:a5:1c:
changing supported rates not implemented
[  339.550000] ath10k: wmi peer delete vdev_id 0 peer_addr 04:f0:21:0c:a5:1c
[  339.550000] ath10k: wmi peer create vdev_id 0 peer_addr 04:f0:21:0c:a5:1c
[  339.550000] ath10k: mac ht peer 04:f0:21:0c:a5:1c mcs cnt 24 nss 1
[  339.550000] ath10k: mac peer 04:f0:21:0c:a5:1c phymode 11na-ht20
[  339.550000] ath10k: wmi peer assoc vdev 0 addr 04:f0:21:0c:a5:1c
[  339.550000] ath10k: wmi vdev 0 peer 0x04:f0:21:0c:a5:1c set param 1 value 1
[  339.850000] ath10k: wmi event debug mesg len 84

Try to re-associate by simply tweaking the peer_new_assoc bit also the same.

Anyone has any ideas?

-----
Chun-Yeow