[PATCH v3 00/13] ath10k: dual-firmware support (MAIN and 10.X)

[Kalle Valo]

Bartosz Markowski <bartosz.markowski at tieto.com> writes:

> The major changes covered by this work:
> * dynamic WMI structures
> * WMI cmd/event definitions from 10.x FW track
> * memory host chunks feature
> * management frames path over WMI for 10.x
> * WMI RX events handling for MAIN and 10.X split
> * target config split (LARGE AP feature for 10.x)
> * scan start sctructure split
> * dynamic VDEV and PDEV parameters structures
>
> Changes in v2:
> (review comments from Kalle and Michal):
> * WMI cmd, pdev and vdev params names trimmed
> * ath10k_wmi_cmd_init() exposed only
> * few 'if' statements simplifications
> * 10.x mgmt frames over WMI - 'BUG: scheduling while atomic' fixed
>
> Changes in v3:
> * print cmd_id when warning about unsupported WMI command
> * remove excessive empty line
>
> Bartosz Markowski (13):
>   ath10k: introduce dynamic WMI structures
>   ath10k: add wmi_10x_<cmd/event> definitions
>   ath10k: warn if give WMI command is not supported
>   ath10k: implement WMI events handling frame for both firmwares
>   ath10k: split ath10k_wmi_service_ready_event_rx
>   ath10k: drop the fw versioning sanity check
>   ath10k: implement host memory chunks
>   ath10k: bring back the WMI path for mgmt frames
>   ath10k: split wmi_cmd_init path
>   ath10k: add TARGET values for 10.x firmware
>   ath10k: introduce dynamic vdev parameters
>   ath10k: introduce dynamic pdev parameters
>   ath10k: handle FW API differences for scan structures

Thanks, all 13 applied.

-- 
Kalle Valo