[PATCH v2 00/13] ath10k: dual-firmware support (MAIN and 10.X)

[Kalle Valo]

Bartosz Markowski <bartosz.markowski at tieto.com> writes:

> This patch-set adds framework for dynamic support of 10.X FW branch.
>
> The major changes covered by this work:
> * dynamic WMI structures
> * WMI cmd/event definitions from 10.x FW track
> * memory host chunks feature
> * management frames path over WMI for 10.x
> * WMI RX events handling for MAIN and 10.X split
> * target config split (LARGE AP feature for 10.x)
> * scan start sctructure split
> * dynamic VDEV and PDEV parameters structures
>
> Changes in v2 
> (review comments from Kalle and Michal):
> * WMI cmd, pdev and vdev params names trimmed
> * ath10k_wmi_cmd_init() exposed only
> * few 'if' statements simplifications
> * 10.x mgmt frames over WMI - 'BUG: scheduling while atomic' fixed

This is looking very good now, I had only had few nitpicks which I found
while reviewing this.

-- 
Kalle Valo