[PATCH] ath10k: Calculate correct peer PHY mode for VHT

[Kalle Valo]

Kalle Valo <kvalo at qca.qualcomm.com> writes:

> From: Sujith Manoharan <c_manoha at qca.qualcomm.com>
>
> The peer PHY mode for 11ac operation needs to be determined
> properly based on the channel bandwidth being used. Fix
> this so that the proper mode is given to the firmware.
>
> kvalo: earlier we used 11na-ht20 in STA mode for 11ac AP peer, this
> patch changes that to 11ac-vht80. I didn't notice any change in
> throughput in my tests, but nevertheless it's the right thing
> to do.
>
> Signed-off-by: Sujith Manoharan <c_manoha at qca.qualcomm.com>
> Signed-off-by: Kalle Valo <kvalo at qca.qualcomm.com>

Applied. Thanks Sujith.

-- 
Kalle Valo