[wireless-regdb] [PATCH v1 03/12] crypto: qat - address recursive dependency when fw signing is enabled
Herbert Xu
herbert at gondor.apana.org.au
Tue May 5 20:33:30 PDT 2015
On Tue, May 05, 2015 at 05:44:21PM -0700, Luis R. Rodriguez wrote:
> From: "Luis R. Rodriguez" <mcgrof at suse.com>
>
> We're going to add firmware module signing support, but when we do
> this we end up with the following recursive dependency. Fix this by
> just depending on FW_LOADER, which is typically always enabled
> anyway.
>
> mcgrof at ergon ~/linux-next (git::master)$ make allnoconfig
> scripts/kconfig/conf --allnoconfig Kconfig
> crypto/Kconfig:15:error: recursive dependency detected!
> crypto/Kconfig:15: symbol CRYPTO is selected by SYSDATA_SIG
> init/Kconfig:1880: symbol SYSDATA_SIG is selected by FIRMWARE_SIG
> drivers/base/Kconfig:88: symbol FIRMWARE_SIG depends on FW_LOADER
> drivers/base/Kconfig:80: symbol FW_LOADER is selected by CRYPTO_DEV_QAT
> drivers/crypto/qat/Kconfig:1: symbol CRYPTO_DEV_QAT is selected by CRYPTO_DEV_QAT_DH895xCC
> drivers/crypto/qat/Kconfig:13: symbol CRYPTO_DEV_QAT_DH895xCC depends on CRYPTO
This doesn't look like a real cycle to me so perhaps we can fix
kbuild to understand this?
Cheers,
--
Email: Herbert Xu <herbert at gondor.apana.org.au>
Home Page: http://gondor.apana.org.au/~herbert/
PGP Key: http://gondor.apana.org.au/~herbert/pubkey.txt
More information about the wireless-regdb
mailing list