[OpenWrt-Devel] [PATCH v2] ath79: add support for gl-ar750
Luochongjun
luochongjun at gl-inet.com
Fri Aug 23 05:05:57 EDT 2019
This patch supports gl-ar750, which was previously supported by ar71xx.
Specification:
- SOC: QCA9531 (650MHz)
- Flash: 16 MiB (W25Q128FVSG)
- RAM: 128 MiB DDR2
- Ethernet: 10/100: 2xLAN + 10/100: 1xWAN
- Wireless: 2.4GHz (bgn) and 5GHz (ac)
- USB: 1x USB 2.0 port
- Switch: 1x switch
- Button: 1x reset button
- LED: 3x LEDS (white)
Flash instruction:
Support for sysupgrade directive upgrades, as well as luci upgrades.
Signed-off-by: Luochongjun <luochongjun at gl-inet.com>
---
.../linux/ath79/base-files/etc/board.d/02_network | 5 +
.../etc/hotplug.d/firmware/11-ath10k-caldata | 1 +
target/linux/ath79/dts/qca9531_glinet_gl-ar750.dts | 142 +++++++++++++++++++++
target/linux/ath79/image/generic.mk | 10 ++
4 files changed, 158 insertions(+)
create mode 100644 target/linux/ath79/dts/qca9531_glinet_gl-ar750.dts
diff --git a/target/linux/ath79/base-files/etc/board.d/02_network b/target/linux/ath79/base-files/etc/board.d/02_network
index cb0853e..454f57d 100755
--- a/target/linux/ath79/base-files/etc/board.d/02_network
+++ b/target/linux/ath79/base-files/etc/board.d/02_network
@@ -156,6 +156,11 @@ ath79_setup_interfaces()
etactica,eg200)
ucidef_set_interface_lan "eth0" "dhcp"
;;
+ glinet,gl-ar750)
+ ucidef_set_interface_wan "eth1"
+ ucidef_add_switch "switch0" \
+ "0 at eth0" "1:lan" "2:lan"
+ ;;
glinet,gl-ar750s)
ucidef_add_switch "switch0" \
"0 at eth0" "2:lan:2" "3:lan:1" "1:wan"
diff --git a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
index 421fb7d..ed34322 100644
--- a/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
+++ b/target/linux/ath79/base-files/etc/hotplug.d/firmware/11-ath10k-caldata
@@ -122,6 +122,7 @@ case "$FIRMWARE" in
ath10kcal_extract "art" 0x5000 0x844
ath10kcal_patch_mac $(macaddr_add $(cat /sys/class/net/eth0/address) +1)
;;
+ glinet,gl-ar750|\
glinet,gl-ar750s)
ath10kcal_extract "art" 0x5000 0x844
ath10kcal_patch_mac $(macaddr_add $(mtd_get_mac_binary art 0x0) +1)
diff --git a/target/linux/ath79/dts/qca9531_glinet_gl-ar750.dts b/target/linux/ath79/dts/qca9531_glinet_gl-ar750.dts
new file mode 100644
index 0000000..54aad32
--- /dev/null
+++ b/target/linux/ath79/dts/qca9531_glinet_gl-ar750.dts
@@ -0,0 +1,142 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+/dts-v1/;
+
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+
+#include "qca953x.dtsi"
+
+/ {
+ compatible = "glinet,gl-ar750", "qca,qca9531";
+ model = "GL.iNet GL-AR750";
+
+ keys {
+ compatible = "gpio-keys";
+
+ pinctrl-names = "default";
+ pinctrl-0 = <&jtag_disable_pins>;
+
+ reset {
+ label = "reset";
+ linux,code = <KEY_RESTART>;
+ gpios = <&gpio 3 GPIO_ACTIVE_LOW>;
+ };
+
+ mode {
+ label = "mode";
+ linux,code = <BTN_0>;
+ gpios = <&gpio 0 GPIO_ACTIVE_LOW>;
+ };
+ };
+
+ leds {
+ compatible = "gpio-leds";
+
+ power {
+ label = "gl-ar750:white:power";
+ gpios = <&gpio 12 GPIO_ACTIVE_LOW>;
+ default-state = "on";
+ };
+
+ wlan2g {
+ label = "gl-ar750:white:wlan2g";
+ gpios = <&gpio 14 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy1tpt";
+ };
+
+ wlan5g {
+ label = "gl-ar750:white:wlan5g";
+ gpios = <&gpio 13 GPIO_ACTIVE_LOW>;
+ linux,default-trigger = "phy0tpt";
+ };
+
+ };
+
+ i2c {
+ compatible = "i2c-gpio";
+
+ sda-gpios = <&gpio 17 GPIO_ACTIVE_LOW>;
+ scl-gpios = <&gpio 16 GPIO_ACTIVE_LOW>;
+ };
+
+
+};
+
+&pcie0 {
+ status = "okay";
+
+ wifi at 0,0 {
+ compatible = "qcom,ath10k";
+ reg = <0 0 0 0 0>;
+ device_type = "pci";
+ };
+};
+
+&uart {
+ status = "okay";
+};
+
+&usb0 {
+ status = "okay";
+};
+
+&usb_phy {
+ status = "okay";
+};
+
+&spi {
+ status = "okay";
+ num-cs = <0>;
+
+ flash at 0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <25000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition at 0 {
+ label = "u-boot";
+ reg = <0x000000 0x040000>;
+ read-only;
+ };
+
+ partition at 40000 {
+ label = "u-boot-env";
+ reg = <0x040000 0x010000>;
+ read-only;
+ };
+
+ art: partition at 50000 {
+ label = "art";
+ reg = <0x050000 0x010000>;
+ read-only;
+ };
+
+ partition at 60000 {
+ compatible = "denx,uimage";
+ label = "firmware";
+ reg = <0x060000 0xfa0000>;
+ };
+ };
+ };
+};
+
+ð0 {
+ status = "okay";
+ mtd-mac-address = <&art 0x0>;
+ phy-handle = <&swphy4>;
+};
+
+ð1 {
+ mtd-mac-address = <&art 0x0>;
+ mtd-mac-address-increment = <1>;
+};
+
+&wmac {
+ status = "okay";
+ mtd-cal-data = <&art 0x1000>;
+};
diff --git a/target/linux/ath79/image/generic.mk b/target/linux/ath79/image/generic.mk
index 6f1ad5b..eed0e2b 100644
--- a/target/linux/ath79/image/generic.mk
+++ b/target/linux/ath79/image/generic.mk
@@ -557,6 +557,16 @@ define Device/glinet_gl-ar300m-nor
endef
TARGET_DEVICES += glinet_gl-ar300m-nor
+define Device/glinet_gl-ar750
+ ATH_SOC := qca9531
+ DEVICE_VENDOR := GL.iNet
+ DEVICE_MODEL := GL-AR750
+ DEVICE_PACKAGES := kmod-usb2 kmod-ath10k-ct ath10k-firmware-qca9887-ct
+ IMAGE_SIZE := 16000k
+ SUPPORTED_DEVICES += gl-ar750
+endef
+TARGET_DEVICES += glinet_gl-ar750
+
define Device/glinet_gl-ar750s
ATH_SOC := qca9563
DEVICE_VENDOR := GL.iNet
--
2.7.4
_______________________________________________
openwrt-devel mailing list
openwrt-devel at lists.openwrt.org
https://lists.openwrt.org/mailman/listinfo/openwrt-devel
More information about the openwrt-devel
mailing list