[PATCH 1/4] ARM: dts: bcm283x: Add dtsi for OTG mode

[Michael Richardson]

Stefan Wahren <stefan.wahren at i2se.com> wrote:
    >> Stefan Wahren <stefan.wahren at i2se.com> wrote:
    >> > The Raspberry Pi Zero also supports OTG mode. So provide a dtsi file
    >> > to configure the USB interface accordingly. The fifo sizes are optimized
    >> > for device endpoint 6 and 7 with the maximum of 768.
    >>
    >> So, in theory, one could wire Pi0 together via OTG cables and run
    >> USB/ethernet between them, right?
    >>

    > I assume you are speaking of two Raspberry Pi Zero. At least one RPi
    > Zero must be configured as host (dr_mode = host) explicit via DTS file.
    > Configure both as OTG shouldn't work. But i didn't test it in the lack
    > of two RPi Zero.

RPI0, or OrangePi0, etc.
We have to configure it via DTS file... hmm.
Not dynamically... that's less fun as it means different devices.

--
]               Never tell me the odds!                 | ipv6 mesh networks [
]   Michael Richardson, Sandelman Software Works        | network architect  [
]     mcr at sandelman.ca  http://www.sandelman.ca/        |   ruby on rails    [