[PATCH V5 1/2] dt-bindings: thermal: add support for Broadcom's Northstar thermal

[Rafał Miłecki]

From: Rafał Miłecki <rafal at milecki.pl>

This commit documents binding for thermal used in Northstar family SoCs.

There isn't any known Northstar device with active cooling system so DT
example has empty cooling-maps node. There is also no support for CPU
frequency throttling so I put only a critical trip in the example.

Signed-off-by: Rafał Miłecki <rafal at milecki.pl>
---
V3: Add thermal-zones to the example
V5: Extend example by including trips and cooling-maps. Update commit message
---
 .../devicetree/bindings/thermal/brcm,ns-thermal    | 37 ++++++++++++++++++++++
 1 file changed, 37 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/thermal/brcm,ns-thermal

diff --git a/Documentation/devicetree/bindings/thermal/brcm,ns-thermal b/Documentation/devicetree/bindings/thermal/brcm,ns-thermal
new file mode 100644
index 000000000000..68e047170039
--- /dev/null
+++ b/Documentation/devicetree/bindings/thermal/brcm,ns-thermal
@@ -0,0 +1,37 @@
+* Broadcom Northstar Thermal
+
+This binding describes thermal sensor that is part of Northstar's DMU (Device
+Management Unit).
+
+Required properties:
+- compatible : Must be "brcm,ns-thermal"
+- reg : iomem address range of PVTMON registers
+- #thermal-sensor-cells : Should be <0>
+
+Example:
+
+thermal: thermal at 1800c2c0 {
+	compatible = "brcm,ns-thermal";
+	reg = <0x1800c2c0 0x10>;
+	#thermal-sensor-cells = <0>;
+};
+
+thermal-zones {
+	cpu_thermal: cpu-thermal {
+		polling-delay-passive = <0>;
+		polling-delay = <1000>;
+		coefficients = <(-556) 418000>;
+		thermal-sensors = <&thermal>;
+
+		trips {
+			cpu-crit {
+				temperature	= <125000>;
+				hysteresis	= <0>;
+				type		= "critical";
+			};
+		};
+
+		cooling-maps {
+		};
+	};
+};
-- 
2.11.0