[PATCH 27/32] gpio: Add support for the FXL6408 GPIO expander.

[Linus Walleij]

On Wed, Jun 1, 2016 at 11:43 PM, Gerd Hoffmann <kraxel at redhat.com> wrote:

> +#define FXL6408_OUTPUT                 0x05
> +/* Bits here make the output High-Z, instead of the OUTPUT value. */
> +#define FXL6408_OUTPUT_HIGH_Z          0x07
(...)
> +       /* Disable High-Z of outputs, so that our OUTPUT updates
> +        * actually take effect.
> +        */
> +       i2c_smbus_write_byte_data(client, FXL6408_OUTPUT_HIGH_Z, 0);

High-Z is probably the same as open drain right? And if not open drain,
it is push-pull.

So you want to implement .set_single_ended() for configuring the lines in
"high-z", i.e. open drain output mode.

Yours,
Linus Walleij