[PATCH] ARM: bcm2835: dt: Add Raspberry Pi Model A

[Lubomir Rintel]

This one is essentially the same as revision 2 B board (with the I2S on
P5 header).

Signed-off-by: Lubomir Rintel <lkundrak at v3.sk>
---
 arch/arm/boot/dts/Makefile          |  1 +
 arch/arm/boot/dts/bcm2835-rpi-a.dts | 23 +++++++++++++++++++++++
 2 files changed, 24 insertions(+)
 create mode 100644 arch/arm/boot/dts/bcm2835-rpi-a.dts

diff --git a/arch/arm/boot/dts/Makefile b/arch/arm/boot/dts/Makefile
index a4a6d70..d000814 100644
--- a/arch/arm/boot/dts/Makefile
+++ b/arch/arm/boot/dts/Makefile
@@ -60,6 +60,7 @@ dtb-$(CONFIG_ARCH_AXXIA) += \
 	axm5516-amarillo.dtb
 dtb-$(CONFIG_ARCH_BCM2835) += \
 	bcm2835-rpi-b.dtb \
+	bcm2835-rpi-a.dtb \
 	bcm2835-rpi-b-rev2.dtb \
 	bcm2835-rpi-b-plus.dtb \
 	bcm2835-rpi-a-plus.dtb \
diff --git a/arch/arm/boot/dts/bcm2835-rpi-a.dts b/arch/arm/boot/dts/bcm2835-rpi-a.dts
new file mode 100644
index 0000000..42d6bf8
--- /dev/null
+++ b/arch/arm/boot/dts/bcm2835-rpi-a.dts
@@ -0,0 +1,23 @@
+/dts-v1/;
+#include "bcm2835-rpi.dtsi"
+
+/ {
+	compatible = "raspberrypi,model-a", "brcm,bcm2835";
+	model = "Raspberry Pi Model A";
+
+	leds {
+		act {
+			gpios = <&gpio 16 1>;
+		};
+	};
+};
+
+&gpio {
+	pinctrl-0 = <&gpioout &alt0 &i2s_alt2 &alt3>;
+
+	/* I2S interface */
+	i2s_alt2: i2s_alt2 {
+		brcm,pins = <28 29 30 31>;
+		brcm,function = <BCM2835_FSEL_ALT2>;
+	};
+};
-- 
2.5.0