[PATCH V2 1/2] dt/bindings: serial: bcm2835: add binding documentation for bcm2835-aux-uart

[Martin Sperl]

> On 09.01.2016, at 21:53, Arnd Bergmann <arnd at arndb.de> wrote:
> 
> On Saturday 09 January 2016 13:07:32 kernel at martin.sperl.org wrote:
>> +
>> +       uart1: uart at 7e215040 {
>> +               compatible = "brcm,bcm2835-aux-uart";
>> +               reg = <0x7e215040 0x40>;
>> +               interrupts = <1 29>;
>> +               clocks = <&aux BCM2835_AUX_CLOCK_UART>;
>> +       };
>> 
> 
> The node name should always be "serial at ...", not "uart at ..."
> 
> 	Arnd

The existing dts arch/arm/boot/dts/bcm2835.dtsi already contains:
                uart0: uart at 7e201000 {
                        compatible = "brcm,bcm2835-pl011", "arm,pl011", "arm,primecell";
                        reg = <0x7e201000 0x1000>;
                        interrupts = <2 25>;
                        clocks = <&clocks BCM2835_CLOCK_UART>,
                                 <&clocks BCM2835_CLOCK_VPU>;
                        clock-names = "uartclk", "apb_pclk";
                        arm,primecell-periphid = <0x00241011>;
                };
for the primary uart.

So I was just following that example and would hesitate to
use a different nomenclature in the same file (even though I
saw serial examples elsewhere).

I guess this is a more general thing that needs to get resolved.

If you tell me to re-spin the patch because of this then I can do that,
but that would not solve the issue with uart0.

Thanks,
	Martin