[PATCH 0/5] ASOC: bcm2835: move bcm2835-i2s to use clock framework

[kernel at martin.sperl.org]

From: Martin Sperl <kernel at martin.sperl.org>

This patchset enables the bcm2835-i2s driver to use the clock
framework which was introduced with commit 94cb7f76caa0b337
("Switch to using the new clock driver support").

This commit resulted in the fact that the bcm2835-i2s driver was
no longer working due to some register addresses used by 2 drivers
(clk-bcm2835 and bcm2835-i2s).

To make it all possible this also required the introduction
of the PCM clock into the clk-bcm2835 driver. This patchset
relies on the patch by Remi Pommarel <repk at triplefau.lt>
that introduces the ability to set parent clocks
("clk: bcm2835: Support for clock parent selection"), which is
(as far as I understood) in clk-next and slated for 4.5.

Note that there is one regression: the clk-bcm2835 does not yet
support the mash functionality which the SOC-Hw supports, this
may result in slightly more "audiable noise" than the original
driver. But as this is more about making the driver functional
again, this is - I believe - a drawback we can accept for now.

Martin Sperl (5):
  ASoC: bcm2835: cleanup includes by ordering them alphabetically
  clk: bcm2835: enable management of PCM clock
  ASoC: bcm2835: move to use the clock framework
  ARM: bcm2835: I2S: use new register-range and clock framework
  dt-bindings: bsm2835: fix bindings documentation to use new clock
    framework

 .../devicetree/bindings/sound/brcm,bcm2835-i2s.txt |    7 +-
 arch/arm/boot/dts/bcm2835.dtsi                     |    5 +-
 drivers/clk/bcm/clk-bcm2835.c                      |   15 +
 include/dt-bindings/clock/bcm2835.h                |    3 +-
 sound/soc/bcm/bcm2835-i2s.c                        |  293 +++++---------------
 5 files changed, 91 insertions(+), 232 deletions(-)

--
1.7.10.4