[PATCH V2 RFC 0/6] ARM: dts: bcm2835: Add Raspberry Pi Zero

[Stefan Wahren]

Hi Eric,

> Eric Anholt <eric at anholt.net> hat am 18. August 2016 um 20:14 geschrieben:
> 
> 
> Stefan Wahren <stefan.wahren at i2se.com> writes:
> 
> > This patch series is only a draft and not intended to be merged. Patches 1
> > and 2
> > aren't bcm2835 specific and should be helpful for other platforms. 
> > The patches 2 - 4 are required for otg / gadget mode. The last patch
> > based on the work of Lubomir Rintel [1] and Noralf Trønnes [2].
> >
> > Changes since V1:
> > - rebase to current linux-next
> > - add patches 1 - 4 for otg/gadget support
> > - add patch 5 with model compatible
> > - use polarity define for ACT LED
> >
> > [1] -
> > http://lists.infradead.org/pipermail/linux-rpi-kernel/2016-February/003221.html
> > [2] - https://github.com/raspberrypi/linux/pull/1239/
> >
> > Stefan Wahren (6):
> >   usb: dwc2: core: Avoid nonsense error in gadget mode
> >   usb: dwc2: Add DT properties to specify fifo size in host/otg mode
> >   ARM: dts: bcm283x: Add missing usb clock
> >   ARM: dts: bcm283x: Add generic USB PHY
> >   DT: bindings: bcm: Add Raspberry Pi Zero
> >   ARM: dts: bcm2835: Add Raspberry Pi Zero
> 
> Where are we at on these?  

I would like to split the series:
part 1: Raspberry Pi Zero support (only USB host mode support)
part 2: OTG / Peripheral support for BCM2835 (hope that i reach the point)

> I've been holding off waiting for the USB
> bits to get settled.  I can grab the bindings patch, but is there
> anything else we could merge while you're working on USB?

Maybe i missed something, but i didn't received any ACK from you about this
series.

In case everything is okay, you could also merge patch 3 since it's relevant to
bcm283x and not RPi Zero specific.

Stefan