[PATCH RESEND v2] arm64: dts: rockchip: configure hdmirx in Rock 5 ITX

[Pedro Alves]

Hi,

On 24/03/2026 14:18, Heiko Stuebner wrote:
> Am Montag, 23. März 2026, 10:25:33 Mitteleuropäische Normalzeit schrieb Pedro Alves:
>> +&hdmi_receiver {
>> +	pinctrl-0 = <&hdmim1_rx_cec &hdmim1_rx_hpdin &hdmim1_rx_scl &hdmim1_rx_sda &hdmirx_det>;
>> +	pinctrl-names = "default";
>> +	hpd-gpios = <&gpio1 RK_PC6 GPIO_ACTIVE_LOW>;
> 
> as said before, please also add a pinctrl setting for this pin.
> 
> gpio1_c6 is not part of the main hdmirx set of pins, hence needs an
> additional pinctrl entry to configure it as gpio and possibly set any
> additional pull settings.
> 
> And yes the pinctrl-driver does "implcitly" set the gpio-mode when
> a gpio is requested, but our more modern approach is to always have
> a real pinctrl entry even for gpios.

I am probably getting confused by what you are asking here, but I don't
understand what exactly I should add. There was already a pinctrl for
hdmirx_det (which is what the gpio1_c6 pin is) present in the file,
hence why I did not add it in this patch:

&pinctrl {
	/* ... */
	hdmirx {
		hdmirx_det: hdmirx-det {
			rockchip,pins = <1 RK_PC6 RK_FUNC_GPIO &pcfg_pull_none>;
		};
	};
	/* ... */
};

Looking at the other boards, they do the same thing, but they call it
hdmirx-5v-detection instead, but as discussed in v1 of this patch I
ended up keeping the det naming to match the schematics.

Sorry if I am missing something, I don't have much experience with this,
so I would really appreciate some extra information.

Thank you,
Pedro