[PATCH v2 3/9] media: rockchip: rkcif: add support for rk3588 vicap mipi capture

[Michael Riesch]

Hi Mehdi,

On 3/17/26 14:08, Mehdi Djait wrote:
> Hi Michael,
> 
> Thank you for this nice patch!
> 
> On Tue, Mar 17, 2026 at 10:32:21AM +0100, Michael Riesch via B4 Relay wrote:
>> From: Michael Riesch <michael.riesch at collabora.com>
>>
>> The RK3588 Video Capture (VICAP) unit features a Digital Video Port
>> (DVP) and six MIPI CSI-2 capture interfaces. Add initial support
>> for this variant to the rkcif driver and enable the MIPI CSI-2
>> capture interfaces.
>>
>> Signed-off-by: Michael Riesch <michael.riesch at collabora.com>
> 
> [...]
> 
>>  static inline unsigned int rkcif_mipi_get_reg(struct rkcif_interface *interface,
>>  					      unsigned int index)
>>  {
>> @@ -631,6 +765,8 @@ static int rkcif_mipi_start_streaming(struct rkcif_stream *stream)
>>  	rkcif_mipi_stream_write(stream, RKCIF_MIPI_CTRL1, ctrl1);
>>  	rkcif_mipi_stream_write(stream, RKCIF_MIPI_CTRL0, ctrl0);
>>  
>> +	rkcif_mipi_write(interface, RKCIF_MIPI_CTRL, RKCIF_MIPI_CTRL_CAP_EN);
>> +
> 
> while this is the correct solution for rk3588, for the rk3568 vicap this
> will write 0x1 to the VICAP_MIPI_CTRL : 0x00A0 which will enable the water line.

nice catch ;-) However, the TRM (at least my version) claims that this
bit has a reset value of 0x1, so the bit in question should be already
set in the first place. Thus I decided to *not* make variant specific
code paths.

Do you see problems in your setup?

> 
> --
> Kind Regards
> Mehdi Djait

Best regards,
Michael