[PATCH v8 00/39] Add HDMI 2.0 support to DW HDMI QP TX

[Cristian Ciocaltea]

On 7/6/26 11:33 AM, Maud Spierings wrote:
>> Enable HDMI 2.0 display modes (e.g. 4K at 60Hz) on the Synopsys DW HDMI QP
>> TX controller, as found in Rockchip RK3576 & RK3588 SoCs, by adding SCDC
>> management for high TMDS clock ratio and scrambling.
>>
>> Since SCDC state is lost on sink disconnects, the bridge driver needs to
>> trigger a CRTC reset during connector detection.  To support this, the
>> series introduces the connector and bridge scrambling infrastructure
>> (patches 1-8), wires it up through the bridge connector layer with an
>> atomic-aware detect_ctx hook (patches 9-11), then implements the SCDC
>> scrambling feature in the DW HDMI QP bridge driver (patches 12-15).
>>
>> Patches 16-18 are minor cleanups in the Rockchip platform driver.
>> Patches 19-23 improve HPD handling by deferring IRQ registration until
>> the connector is fully initialized, adding .enable_hpd()/.disable_hpd()
>> PHY ops, and restricting HPD events to the affected connector.
>>
>> Patches 24-25 convert vc4 HDMI to the common SCDC scrambling helpers as
>> a proof of reuse, replacing the driver-local scrambling implementation.
>>
>> Patches 26-30 add KUnit tests: connector scrambler validation, a new
>> 4K at 60Hz 600MHz EDID, hdmi_state_helper scrambling tests, and EDID
>> conformity fixes for some of the existing test blobs.
>>
>> This has been tested on the following boards:
>>
>> * Radxa ROCK 5B (RK3588)
>> * Radxa ROCK 4D (RK3576)
>> * Raspberry Pi 5 Model B Rev 1.1 (BCM2712 D0)
>>
>> Note that commit d87773de9efe1 ("clocksource/drivers/arm_arch_timer:
>> Default to EL2 virtual timer when running VHE"), introduced in v7.2-rc1,
>> causes Raspberry Pi 5 to hang during boot.  Reverting the commit
>> restores normal boot.  This issue has already been reported in [1];
>> alternatively, the workaround proposed in [2] can be applied.
>>
>> Regards,
>> Cristian
>>
>> [1] https://lore.kernel.org/all/ea15cce1-b393-43f6-8d58-3d6f90f0c0cd@samsung.com/
>> [2] https://lore.kernel.org/all/20260619204832.586079-1-dan@reactivated.net/
>>
>> Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea at collabora.com>
> 
> Tested on an Orangepi 5+ board (rk3588), with a 4k60 tv and a 1440p100 monitor.
> 
> To all applicable patches:
> 
> Tested-by: Maud Spierings <maud_spierings at hotmail.com>

Thanks for checking this out!

b4 will apply the tag to all patches, but I'll manually drop it from the VC4 and
KUnit related patches, and probably some others that aren't really testable
as-is.

Cristian