[PATCH 2/5] arm64: dts: rockchip: Fix Turing RK1 PCIe3 hang

[Sam Edwards]

The PCIe 3 PHY in the RK3588 requires a running external reference clock
for both external bus transfers and some internal PIPE operations.
Without this clock, the PCIe3 controller fails to initialize and ignores
DBI transactions indefinitely, which stalls the Linux boot process.

On most RK3588 boards, this is evidently not an issue. But on some "SoM"
designs (Turing RK1, Mixtile Core 3588E, ArmSoM AIM7, to name a few),
this clock is only provided when the CLKREQ# signal is asserted.

The PCIe 3 PHY generates the CLKREQ# signal when it knows it needs the
reference clock for proper operation. Unfortunately, the current DT for
Turing RK1 does not mux out these low-speed signals, resulting in broken
boots and potentially other issues.

This patch, following the previous one that split up the PCIe pinctrls,
resolves this problem for Turing RK1 by explicitly muxing all of the
signals needed for PCIe 2 and 3 support.

Cc: Jonathan Bennett <jbennett at incomsystems.biz>
Fixes: 2806a69f3f ("arm64: dts: rockchip: Add Turing RK1 SoM support")
Signed-off-by: Sam Edwards <CFSworks at gmail.com>
---
 arch/arm64/boot/dts/rockchip/rk3588-turing-rk1.dtsi | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3588-turing-rk1.dtsi b/arch/arm64/boot/dts/rockchip/rk3588-turing-rk1.dtsi
index dbaa94ca69f4..9bcb5acdea54 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588-turing-rk1.dtsi
+++ b/arch/arm64/boot/dts/rockchip/rk3588-turing-rk1.dtsi
@@ -211,7 +211,7 @@ rgmii_phy: ethernet-phy at 1 {
 &pcie2x1l1 {
 	linux,pci-domain = <1>;
 	pinctrl-names = "default";
-	pinctrl-0 = <&pcie2_reset>;
+	pinctrl-0 = <&pcie2_reset>, <&pcie30x1m1_0_clkreqn>, <&pcie30x1m1_0_waken>;
 	reset-gpios = <&gpio4 RK_PA2 GPIO_ACTIVE_HIGH>;
 	status = "okay";
 };
@@ -223,7 +223,7 @@ &pcie30phy {
 &pcie3x4 {
 	linux,pci-domain = <0>;
 	pinctrl-names = "default";
-	pinctrl-0 = <&pcie3_reset>;
+	pinctrl-0 = <&pcie3_reset>, <&pcie30x4m1_clkreqn>, <&pcie30x4m1_waken>;
 	reset-gpios = <&gpio4 RK_PB6 GPIO_ACTIVE_HIGH>;
 	vpcie3v3-supply = <&vcc3v3_pcie30>;
 	status = "okay";
-- 
2.44.2