[PATCH 3/3] arm64: dts: rockchip: add dts for Ariaboard Photonicat RK3568

[Andrew Lunn]

> +&gmac1 {
> +	assigned-clocks = <&cru SCLK_GMAC1_RX_TX>, <&cru SCLK_GMAC1>;
> +	assigned-clock-parents = <&cru SCLK_GMAC1_RGMII_SPEED>;
> +	assigned-clock-rates = <0>, <125000000>;
> +	clock_in_out = "output";
> +	phy-handle = <&rgmii_phy1>;
> +	phy-mode = "rgmii";
> +	phy-supply = <&vcc_3v3>;
> +	pinctrl-names = "default";
> +	pinctrl-0 = <&gmac1m1_miim
> +		     &gmac1m1_tx_bus2
> +		     &gmac1m1_rx_bus2
> +		     &gmac1m1_rgmii_clk
> +		     &gmac1m1_rgmii_bus>;
> +	snps,reset-gpio = <&gpio4 RK_PC0 GPIO_ACTIVE_LOW>;
> +	snps,reset-active-low;
> +	snps,reset-delays-us = <0 20000 100000>;
> +	tx_delay = <0x38>;
> +	rx_delay = <0x15>;
> +	status = "okay";

This has been discussed a few times. You should be using phy-mode
rgmii-id.

arch/arm/boot/dts/rockchip/rk3288-phycore-som.dtsi is i think also a
YT8521SC.

	Andrew