[PATCH v2] arm64: dts: rockchip: Correct GPIO polarity on brcm BT nodes

[Dragan Simic]

Hello Diederik,

On 2024-10-18 16:45, Diederik de Haas wrote:
> Paragraph "3.4 Power up Timing Sequence" of the AzureWave-CM256SM
> datasheet mentions the following about the BT_REG_ON pin, which is
> connected to GPIO0_C4_d:
> 
>   When this pin is low and WL_REG_ON is high,
>   the BT section is in reset.
> 
> Therefor set that pin to GPIO_ACTIVE_HIGH so that it can be pulled low
> for a reset.
> If set to GPIO_ACTIVE_LOW, the following errors are observed:
> 
>   Bluetooth: hci0: command 0x0c03 tx timeout
>   Bluetooth: hci0: BCM: Reset failed (-110)
> 
> So fix the GPIO polarity by setting it to ACTIVE_HIGH.
> This also matches what other devices with the same BT device have.
> 
> Fixes: a3a625086192 ("arm64: dts: rockchip: Fix reset-gpios property
> on brcm BT nodes")
> Signed-off-by: Diederik de Haas <didi.debian at cknow.org>

I'm a bit late to the party, :) but just wanted to confirm that
the information provided in the patch description is correct.

> ---
> Changes in v2:
> - Better commit description with references to the datasheet
> - Dropped the (self-)blame as it's not useful to evaluate the 
> usefulness
>   of this patch
> 
>  arch/arm64/boot/dts/rockchip/rk3566-pinenote.dtsi  | 2 +-
>  arch/arm64/boot/dts/rockchip/rk3566-radxa-cm3.dtsi | 2 +-
>  2 files changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/arch/arm64/boot/dts/rockchip/rk3566-pinenote.dtsi
> b/arch/arm64/boot/dts/rockchip/rk3566-pinenote.dtsi
> index a477bd992b40..0131f2cdd312 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3566-pinenote.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk3566-pinenote.dtsi
> @@ -688,7 +688,7 @@ bluetooth {
>  		host-wakeup-gpios = <&gpio0 RK_PC3 GPIO_ACTIVE_HIGH>;
>  		pinctrl-0 = <&bt_enable_h>, <&bt_host_wake_l>, <&bt_wake_h>;
>  		pinctrl-names = "default";
> -		shutdown-gpios = <&gpio0 RK_PC4 GPIO_ACTIVE_LOW>;
> +		shutdown-gpios = <&gpio0 RK_PC4 GPIO_ACTIVE_HIGH>;
>  		vbat-supply = <&vcc_wl>;
>  		vddio-supply = <&vcca_1v8_pmu>;
>  	};
> diff --git a/arch/arm64/boot/dts/rockchip/rk3566-radxa-cm3.dtsi
> b/arch/arm64/boot/dts/rockchip/rk3566-radxa-cm3.dtsi
> index e9fa9bee995a..1e36f73840da 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3566-radxa-cm3.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk3566-radxa-cm3.dtsi
> @@ -404,7 +404,7 @@ bluetooth {
>  		host-wakeup-gpios = <&gpio2 RK_PB1 GPIO_ACTIVE_HIGH>;
>  		pinctrl-names = "default";
>  		pinctrl-0 = <&bt_host_wake_h &bt_reg_on_h &bt_wake_host_h>;
> -		shutdown-gpios = <&gpio2 RK_PC0 GPIO_ACTIVE_LOW>;
> +		shutdown-gpios = <&gpio2 RK_PC0 GPIO_ACTIVE_HIGH>;
>  		vbat-supply = <&vcc_3v3>;
>  		vddio-supply = <&vcc_1v8>;
>  	};