[PATCH v2 09/14] arm64: dts: rockchip: Remove 'enable-active-low' from two boards

[Heiko Stuebner]

The 'enable-active-low' property is not a valid, because it is the
default behaviour of the fixed regulator.

Only 'enable-active-high' is valid, and when this property is absent
the fixed regulator will act as active low by default.

Both the rk3588-orange-pi-5 and the Wolfvision pf5 io expander overlay
smuggled those enable-active-low properties in, so remove them to
make dtbscheck happier.

Fixes: 28799a7734a0 ("arm64: dts: rockchip: add wolfvision pf5 io expander board")
Cc: Michael Riesch <michael.riesch at wolfvision.net>
Fixes: b6bc755d806e ("arm64: dts: rockchip: Add Orange Pi 5")
Cc: Muhammed Efe Cetin <efectn at 6tel.net>

Signed-off-by: Heiko Stuebner <heiko at sntech.de>
---
 .../boot/dts/rockchip/rk3568-wolfvision-pf5-io-expander.dtso     | 1 -
 arch/arm64/boot/dts/rockchip/rk3588s-orangepi-5.dts              | 1 -
 2 files changed, 2 deletions(-)

diff --git a/arch/arm64/boot/dts/rockchip/rk3568-wolfvision-pf5-io-expander.dtso b/arch/arm64/boot/dts/rockchip/rk3568-wolfvision-pf5-io-expander.dtso
index ebcaeafc3800..fa61633aea15 100644
--- a/arch/arm64/boot/dts/rockchip/rk3568-wolfvision-pf5-io-expander.dtso
+++ b/arch/arm64/boot/dts/rockchip/rk3568-wolfvision-pf5-io-expander.dtso
@@ -49,7 +49,6 @@ vcc1v8_eth: vcc1v8-eth-regulator {
 
 	vcc3v3_eth: vcc3v3-eth-regulator {
 		compatible = "regulator-fixed";
-		enable-active-low;
 		gpio = <&gpio0 RK_PC0 GPIO_ACTIVE_LOW>;
 		pinctrl-names = "default";
 		pinctrl-0 = <&vcc3v3_eth_enn>;
diff --git a/arch/arm64/boot/dts/rockchip/rk3588s-orangepi-5.dts b/arch/arm64/boot/dts/rockchip/rk3588s-orangepi-5.dts
index feea6b20a6bf..6b77be643249 100644
--- a/arch/arm64/boot/dts/rockchip/rk3588s-orangepi-5.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3588s-orangepi-5.dts
@@ -71,7 +71,6 @@ vcc5v0_sys: vcc5v0-sys-regulator {
 
 	vcc_3v3_sd_s0: vcc-3v3-sd-s0-regulator {
 		compatible = "regulator-fixed";
-		enable-active-low;
 		gpios = <&gpio4 RK_PB5 GPIO_ACTIVE_LOW>;
 		regulator-name = "vcc_3v3_sd_s0";
 		regulator-boot-on;
-- 
2.43.0