[PATCH v3 4/5] arm64: dts: rockchip: Add OPP data for CPU cores on RK3588
Dragan Simic
dsimic at manjaro.org
Thu Feb 29 22:31:33 PST 2024
On 2024-02-29 20:26, Alexey Charkov wrote:
> By default the CPUs on RK3588 start up in a conservative performance
> mode. Add frequency and voltage mappings to the device tree to enable
> dynamic scaling via cpufreq.
>
> OPP values are adapted from Radxa's downstream kernel for Rock 5B [1],
> stripping them down to the minimum frequency and voltage combinations
> as expected by the generic upstream cpufreq-dt driver, and also
> dropping
> those OPPs that don't differ in voltage but only in frequency (keeping
> the top frequency OPP in each case).
Please, let's consider extracting the OPPs into a separate
rk3588s-opp.dtsi
file, as I already explained in detail and proposed in the message
linked
below. To be fair, it might also be seen as redundant, because the
RK3399
does that because of the need for different OPPs for different RK3399
SoC
variants, but it would make leaving the TSADC disabled 100% safe.
Though, the RK3328 SoC dtsi also leaves the TSADC disabled on the SoC
level
and enables it for each RK3328-based board, so I'm no longer sure do we
really need a separate rk3588s-opp.dtsi file to be on the 100% safe side
with the TSADC disabled on the RK3588(s) SoC level.
-
https://lore.kernel.org/linux-rockchip/ad00189e1a25ca90128be6c8b3841b77@manjaro.org/
> Note that this patch ignores voltage scaling for the CPU memory
> interface which the downstream kernel does through a custom cpufreq
> driver, and which is why the downstream version has two sets of voltage
> values for each OPP (the second one being meant for the memory
> interface supply regulator). This is done instead via regulator
> coupling between CPU and memory interface supplies on affected boards.
I'm still digging through various documents, to find a more clear
explanation
of what those *_MEM_* voltages are exactly for. I'll reply in more
detail in
the respective patch thread, of course.
> This has been tested on Rock 5B with u-boot 2023.11 compiled from
> Collabora's integration tree [2] with binary bl31 and appears to be
> stable both under active cooling and passive cooling (with throttling)
>
> [1]
> https://github.com/radxa/kernel/blob/stable-5.10-rock5/arch/arm64/boot/dts/rockchip/rk3588s.dtsi
> [2]
> https://gitlab.collabora.com/hardware-enablement/rockchip-3588/u-boot
>
> Signed-off-by: Alexey Charkov <alchark at gmail.com>
> ---
> arch/arm64/boot/dts/rockchip/rk3588s.dtsi | 122
> ++++++++++++++++++++++++++++++
> 1 file changed, 122 insertions(+)
>
> diff --git a/arch/arm64/boot/dts/rockchip/rk3588s.dtsi
> b/arch/arm64/boot/dts/rockchip/rk3588s.dtsi
> index 9bf197358642..bd39c5c47bfb 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3588s.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk3588s.dtsi
> @@ -97,6 +97,7 @@ cpu_l0: cpu at 0 {
> clocks = <&scmi_clk SCMI_CLK_CPUL>;
> assigned-clocks = <&scmi_clk SCMI_CLK_CPUL>;
> assigned-clock-rates = <816000000>;
> + operating-points-v2 = <&cluster0_opp_table>;
> cpu-idle-states = <&CPU_SLEEP>;
> i-cache-size = <32768>;
> i-cache-line-size = <64>;
> @@ -116,6 +117,7 @@ cpu_l1: cpu at 100 {
> enable-method = "psci";
> capacity-dmips-mhz = <530>;
> clocks = <&scmi_clk SCMI_CLK_CPUL>;
> + operating-points-v2 = <&cluster0_opp_table>;
> cpu-idle-states = <&CPU_SLEEP>;
> i-cache-size = <32768>;
> i-cache-line-size = <64>;
> @@ -135,6 +137,7 @@ cpu_l2: cpu at 200 {
> enable-method = "psci";
> capacity-dmips-mhz = <530>;
> clocks = <&scmi_clk SCMI_CLK_CPUL>;
> + operating-points-v2 = <&cluster0_opp_table>;
> cpu-idle-states = <&CPU_SLEEP>;
> i-cache-size = <32768>;
> i-cache-line-size = <64>;
> @@ -154,6 +157,7 @@ cpu_l3: cpu at 300 {
> enable-method = "psci";
> capacity-dmips-mhz = <530>;
> clocks = <&scmi_clk SCMI_CLK_CPUL>;
> + operating-points-v2 = <&cluster0_opp_table>;
> cpu-idle-states = <&CPU_SLEEP>;
> i-cache-size = <32768>;
> i-cache-line-size = <64>;
> @@ -175,6 +179,7 @@ cpu_b0: cpu at 400 {
> clocks = <&scmi_clk SCMI_CLK_CPUB01>;
> assigned-clocks = <&scmi_clk SCMI_CLK_CPUB01>;
> assigned-clock-rates = <816000000>;
> + operating-points-v2 = <&cluster1_opp_table>;
> cpu-idle-states = <&CPU_SLEEP>;
> i-cache-size = <65536>;
> i-cache-line-size = <64>;
> @@ -194,6 +199,7 @@ cpu_b1: cpu at 500 {
> enable-method = "psci";
> capacity-dmips-mhz = <1024>;
> clocks = <&scmi_clk SCMI_CLK_CPUB01>;
> + operating-points-v2 = <&cluster1_opp_table>;
> cpu-idle-states = <&CPU_SLEEP>;
> i-cache-size = <65536>;
> i-cache-line-size = <64>;
> @@ -215,6 +221,7 @@ cpu_b2: cpu at 600 {
> clocks = <&scmi_clk SCMI_CLK_CPUB23>;
> assigned-clocks = <&scmi_clk SCMI_CLK_CPUB23>;
> assigned-clock-rates = <816000000>;
> + operating-points-v2 = <&cluster2_opp_table>;
> cpu-idle-states = <&CPU_SLEEP>;
> i-cache-size = <65536>;
> i-cache-line-size = <64>;
> @@ -234,6 +241,7 @@ cpu_b3: cpu at 700 {
> enable-method = "psci";
> capacity-dmips-mhz = <1024>;
> clocks = <&scmi_clk SCMI_CLK_CPUB23>;
> + operating-points-v2 = <&cluster2_opp_table>;
> cpu-idle-states = <&CPU_SLEEP>;
> i-cache-size = <65536>;
> i-cache-line-size = <64>;
> @@ -348,6 +356,120 @@ l3_cache: l3-cache {
> };
> };
>
> + cluster0_opp_table: opp-table-cluster0 {
> + compatible = "operating-points-v2";
> + opp-shared;
> +
> + opp-1008000000 {
> + opp-hz = /bits/ 64 <1008000000>;
> + opp-microvolt = <675000 675000 950000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-1200000000 {
> + opp-hz = /bits/ 64 <1200000000>;
> + opp-microvolt = <712500 712500 950000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-1416000000 {
> + opp-hz = /bits/ 64 <1416000000>;
> + opp-microvolt = <762500 762500 950000>;
> + clock-latency-ns = <40000>;
> + opp-suspend;
> + };
> + opp-1608000000 {
> + opp-hz = /bits/ 64 <1608000000>;
> + opp-microvolt = <850000 850000 950000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-1800000000 {
> + opp-hz = /bits/ 64 <1800000000>;
> + opp-microvolt = <950000 950000 950000>;
> + clock-latency-ns = <40000>;
> + };
> + };
> +
> + cluster1_opp_table: opp-table-cluster1 {
> + compatible = "operating-points-v2";
> + opp-shared;
> +
> + opp-1200000000 {
> + opp-hz = /bits/ 64 <1200000000>;
> + opp-microvolt = <675000 675000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-1416000000 {
> + opp-hz = /bits/ 64 <1416000000>;
> + opp-microvolt = <725000 725000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-1608000000 {
> + opp-hz = /bits/ 64 <1608000000>;
> + opp-microvolt = <762500 762500 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-1800000000 {
> + opp-hz = /bits/ 64 <1800000000>;
> + opp-microvolt = <850000 850000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-2016000000 {
> + opp-hz = /bits/ 64 <2016000000>;
> + opp-microvolt = <925000 925000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-2208000000 {
> + opp-hz = /bits/ 64 <2208000000>;
> + opp-microvolt = <987500 987500 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-2400000000 {
> + opp-hz = /bits/ 64 <2400000000>;
> + opp-microvolt = <1000000 1000000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + };
> +
> + cluster2_opp_table: opp-table-cluster2 {
> + compatible = "operating-points-v2";
> + opp-shared;
> +
> + opp-1200000000 {
> + opp-hz = /bits/ 64 <1200000000>;
> + opp-microvolt = <675000 675000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-1416000000 {
> + opp-hz = /bits/ 64 <1416000000>;
> + opp-microvolt = <725000 725000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-1608000000 {
> + opp-hz = /bits/ 64 <1608000000>;
> + opp-microvolt = <762500 762500 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-1800000000 {
> + opp-hz = /bits/ 64 <1800000000>;
> + opp-microvolt = <850000 850000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-2016000000 {
> + opp-hz = /bits/ 64 <2016000000>;
> + opp-microvolt = <925000 925000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-2208000000 {
> + opp-hz = /bits/ 64 <2208000000>;
> + opp-microvolt = <987500 987500 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + opp-2400000000 {
> + opp-hz = /bits/ 64 <2400000000>;
> + opp-microvolt = <1000000 1000000 1000000>;
> + clock-latency-ns = <40000>;
> + };
> + };
> +
> firmware {
> optee: optee {
> compatible = "linaro,optee-tz";
More information about the Linux-rockchip
mailing list