[PATCH v6 1/4] drm/rockchip: vop: limit maximium resolution to hardware capabilities

[Heiko Stübner]

Hi Sascha,

Am Donnerstag, 16. Februar 2023, 11:24:44 CET schrieb Sascha Hauer:
> The different VOP variants support different maximum resolutions. Reject
> resolutions that are not supported by a specific variant.
> 
> This hasn't been a problem in the upstream driver so far as 1920x1080
> has been the maximum resolution supported by the HDMI driver and that
> resolution is supported by all VOP variants. Now with higher resolutions
> supported in the HDMI driver we have to limit the resolutions to the
> ones supported by the VOP.
> 
> The actual maximum resolutions are taken from the Rockchip downstream
> Kernel.
> 
> Signed-off-by: Sascha Hauer <s.hauer at pengutronix.de>
> ---
> 
> Notes:
>     Changes since v5:
>     - fix wrong check height vs. width
>     
>     Changes since v4:
>     - Use struct vop_rect for storing resolution
>     
>     Changes since v3:
>     - new patch
> 
>  drivers/gpu/drm/rockchip/rockchip_drm_vop.c  | 15 +++++++++++++++
>  drivers/gpu/drm/rockchip/rockchip_drm_vop.h  |  6 ++++++
>  drivers/gpu/drm/rockchip/rockchip_drm_vop2.h |  5 -----
>  drivers/gpu/drm/rockchip/rockchip_vop_reg.c  | 18 ++++++++++++++++++
>  4 files changed, 39 insertions(+), 5 deletions(-)
> 
> diff --git a/drivers/gpu/drm/rockchip/rockchip_drm_vop.c b/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
> index fa1f4ee6d1950..40c688529d44e 100644
> --- a/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
> +++ b/drivers/gpu/drm/rockchip/rockchip_drm_vop.c
> @@ -1174,6 +1174,20 @@ static void vop_crtc_disable_vblank(struct drm_crtc *crtc)
>  	spin_unlock_irqrestore(&vop->irq_lock, flags);
>  }
>  
> +static enum drm_mode_status vop_crtc_mode_valid(struct drm_crtc *crtc,
> +						const struct drm_display_mode *mode)
> +{
> +	struct vop *vop = to_vop(crtc);
> +
> +	if (vop->data->max_output.width && mode->hdisplay > vop->data->max_output.width)
> +		return MODE_BAD_HVALUE;
> +
> +	if (vop->data->max_output.height && mode->vdisplay > vop->data->max_output.height)
> +		return MODE_BAD_VVALUE;
> +
> +	return MODE_OK;
> +}

I'm very much in favor of codifying the possible resolutions. Hopefully
this will also enable better vop-selection down the road.

But ...

The above does break the px30-minievb display.
While the px30 TRM does say it supports a 1920x1080 resolution only, the
px30-minievb comes with a 720x1280 DSI display and normally runs just
fine with it.

Looking at the vendor-code [0], it seems they only seem to check for the
hvalue. Looking deeper, the height-check was present in the beginning [1],
but then was removed later on.

Looking a bit more, I find [2] which says that
	"Actually vop hardware has no output height limit"

I re-checked this on both px30+dsi and rock64+1080p-hdmi and with
> +	if (vop->data->max_output.height && mode->vdisplay > vop->data->max_output.height)
> +		return MODE_BAD_VVALUE;
line gone, rock64 is still happy and the px30 works correctly again.

So, do you see an issue with removing the output-height check?


Heiko


[0] https://github.com/rockchip-linux/kernel/blob/develop-4.4/drivers/gpu/drm/rockchip/rockchip_drm_vop.c#L2446
[1] https://github.com/rockchip-linux/kernel/commit/7e3e0c5e2eb16901ab5dce1cb981e1ac58fe42c6
[2] https://github.com/rockchip-linux/kernel/commit/28c41da2693fe448aeda7c03070c376290b93805