[RFT PATCH 1/3] arm64: dts: rockchip: correct audio-codec interrupt flag in eaidk-610

[Krzysztof Kozlowski]

On 05/07/2023 08:48, Krzysztof Kozlowski wrote:
> GPIO_ACTIVE_x flags are not correct in the context of interrupt flags.
> These are simple defines so they could be used in DTS but they will not
> have the same meaning: GPIO_ACTIVE_HIGH = 0 = IRQ_TYPE_NONE.
> 
> Correct the interrupt flags, assuming the author of the code wanted same
> logical behavior behind the name "ACTIVE_xxx", this is:
>   ACTIVE_LOW  => IRQ_TYPE_LEVEL_LOW

This should be HIGH in both cases. I will send a v2.

> 
> Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski at linaro.org>
> ---
>  arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts | 2 +-
>  1 file changed, 1 insertion(+), 1 deletion(-)
> 
> diff --git a/arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts b/arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts
> index d1f343345f67..6464ef4d113d 100644
> --- a/arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts
> +++ b/arch/arm64/boot/dts/rockchip/rk3399-eaidk-610.dts
> @@ -773,7 +773,7 @@ brcmf: wifi at 1 {
>  		compatible = "brcm,bcm4329-fmac";
>  		reg = <1>;
>  		interrupt-parent = <&gpio0>;
> -		interrupts = <RK_PA3 GPIO_ACTIVE_HIGH>;
> +		interrupts = <RK_PA3 IRQ_TYPE_LEVEL_HIGH>;

Best regards,
Krzysztof