[PATCH] arm64: dts: rockchip: Enable pcie2 and audio jack on rk3566-roc-pc
Furkan Kardame
f.kardame at manjaro.org
Sun Oct 9 13:07:07 PDT 2022
Add dts nodes to enable combphy2, pcie2 and audio jack.
Disable i2c5 as it not used.
Signed-off-by: Furkan Kardame <f.kardame at manjaro.org>
---
.../arm64/boot/dts/rockchip/rk3566-roc-pc.dts | 97 ++++++++++++++++++-
1 file changed, 93 insertions(+), 4 deletions(-)
diff --git a/arch/arm64/boot/dts/rockchip/rk3566-roc-pc.dts b/arch/arm64/boot/dts/rockchip/rk3566-roc-pc.dts
index dba648c2f..1e5c83012 100644
--- a/arch/arm64/boot/dts/rockchip/rk3566-roc-pc.dts
+++ b/arch/arm64/boot/dts/rockchip/rk3566-roc-pc.dts
@@ -39,6 +39,28 @@ hdmi_con_in: endpoint {
};
};
+ i2s1_8ch: i2s at fe410000 {
+ compatible = "rockchip,rk3568-i2s-tdm";
+ reg = <0x0 0xfe410000 0x0 0x1000>;
+ interrupts = <GIC_SPI 53 IRQ_TYPE_LEVEL_HIGH>;
+ assigned-clocks = <&cru CLK_I2S1_8CH_TX_SRC>, <&cru CLK_I2S1_8CH_RX_SRC>;
+ assigned-clock-rates = <1188000000>, <1188000000>;
+ clocks = <&cru MCLK_I2S1_8CH_TX>, <&cru MCLK_I2S1_8CH_RX>,
+ <&cru HCLK_I2S1_8CH>;
+ clock-names = "mclk_tx", "mclk_rx", "hclk";
+ dmas = <&dmac1 3>, <&dmac1 2>;
+ dma-names = "rx", "tx";
+ resets = <&cru SRST_M_I2S1_8CH_TX>, <&cru SRST_M_I2S1_8CH_RX>;
+ reset-names = "tx-m", "rx-m";
+ rockchip,grf = <&grf>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&i2s1m0_sclktx &i2s1m0_sclkrx
+ &i2s1m0_lrcktx &i2s1m0_lrckrx
+ &i2s1m0_sdi0 &i2s1m0_sdo0>;
+ #sound-dai-cells = <0>;
+ status = "disabled";
+ };
+
leds {
compatible = "gpio-leds";
@@ -53,6 +75,22 @@ led-user {
};
};
+ rk809-sound {
+ compatible = "simple-audio-card";
+ simple-audio-card,format = "i2s";
+ simple-audio-card,name = "STATION-M2-FRONT";
+ simple-audio-card,mclk-fs = <256>;
+ status = "okay";
+
+ simple-audio-card,cpu {
+ sound-dai = <&i2s1_8ch>;
+ };
+
+ simple-audio-card,codec {
+ sound-dai = <&rk809>;
+ };
+ };
+
sdio_pwrseq: sdio-pwrseq {
status = "okay";
compatible = "mmc-pwrseq-simple";
@@ -82,6 +120,18 @@ vcc5v0_sys: vcc5v0-sys-regulator {
vin-supply = <&usb_5v>;
};
+ vcc3v3_pcie: vcc3v3-pcie-regulator {
+ compatible = "regulator-fixed";
+ enable-active-high;
+ gpio = <&gpio0 RK_PC4 GPIO_ACTIVE_HIGH>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pcie_enable_h>;
+ regulator-name = "vcc3v3_pcie";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ vin-supply = <&vcc5v0_sys>;
+ };
+
vcc3v3_sys: vcc3v3-sys-regulator {
compatible = "regulator-fixed";
regulator-name = "vcc3v3_sys";
@@ -122,6 +172,10 @@ &combphy1 {
status = "okay";
};
+&combphy2 {
+ status = "okay";
+};
+
&cpu0 {
cpu-supply = <&vdd_cpu>;
};
@@ -142,7 +196,7 @@ &gmac1 {
assigned-clocks = <&cru SCLK_GMAC1_RX_TX>, <&cru SCLK_GMAC1_RGMII_SPEED>, <&cru SCLK_GMAC1>;
assigned-clock-parents = <&cru SCLK_GMAC1_RGMII_SPEED>, <&cru SCLK_GMAC1>, <&gmac1_clkin>;
clock_in_out = "input";
- phy-mode = "rgmii-id";
+ phy-mode = "rgmii";
phy-supply = <&vcc_3v3>;
pinctrl-names = "default";
pinctrl-0 = <&gmac1m0_miim
@@ -210,9 +264,13 @@ rk809: pmic at 20 {
interrupt-parent = <&gpio0>;
interrupts = <RK_PA7 IRQ_TYPE_LEVEL_LOW>;
clock-output-names = "rk808-clkout1", "rk808-clkout2";
-
+ assigned-clocks = <&cru I2S1_MCLKOUT_TX>;
+ assigned-clock-parents = <&cru CLK_I2S1_8CH_TX>;
+ clock-names = "mclk";
+ clocks = <&cru I2S1_MCLKOUT_TX>;
+ pinctrl-0 = <&pmic_int>, <&i2s1m0_mclk>;
+ #sound-dai-cells = <0>;
pinctrl-names = "default";
- pinctrl-0 = <&pmic_int>;
rockchip,system-power-controller;
wakeup-source;
#clock-cells = <1>;
@@ -419,6 +477,10 @@ vcc3v3_sd: SWITCH_REG2 {
regulator-boot-on;
};
};
+
+ codec {
+ mic-in-differential;
+ };
};
};
@@ -432,11 +494,20 @@ &i2c2 {
&i2c3 {
pinctrl-names = "default";
- pinctrl-0 = <&i2c3m1_xfer>;
+ pinctrl-0 = <&i2c3m0_xfer>;
status = "okay";
};
&i2c5 {
+ status = "disabled";
+};
+
+&i2s0_8ch {
+ status = "okay";
+};
+
+&i2s1_8ch {
+ rockchip,trcm-sync-tx-only;
status = "okay";
};
@@ -447,6 +518,14 @@ rgmii_phy1: ethernet-phy at 0 {
};
};
+&pcie2x1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pcie_reset_h>;
+ reset-gpios = <&gpio1 RK_PB2 GPIO_ACTIVE_HIGH>;
+ vpcie3v3-supply = <&vcc3v3_pcie>;
+ status = "okay";
+};
+
&pinctrl {
bt {
bt_enable_h: bt-enable-h {
@@ -468,6 +547,16 @@ user_led_enable_h: user-led-enable-h {
};
};
+ pcie {
+ pcie_enable_h: pcie-enable-h {
+ rockchip,pins = <0 RK_PC4 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+
+ pcie_reset_h: pcie-reset-h {
+ rockchip,pins = <1 RK_PB2 RK_FUNC_GPIO &pcfg_pull_none>;
+ };
+ };
+
pmic {
pmic_int: pmic_int {
rockchip,pins =
--
2.37.3
More information about the Linux-rockchip
mailing list