[PATCH 4/5] drm/sti/sti_hdmi: Replace drm_detect_hdmi_monitor() with is_hdmi

José Expósito jose.exposito89 at gmail.com
Thu Apr 21 10:07:24 PDT 2022


Once EDID is parsed, the monitor HDMI support information is available
through drm_display_info.is_hdmi.

This driver calls drm_detect_hdmi_monitor() to receive the same
information and stores its own cached value, which is less efficient.

Avoid calling drm_detect_hdmi_monitor() and use drm_display_info.is_hdmi
instead and also remove sti_hdmi.hdmi_monitor as it is no longer
necessary.

Signed-off-by: José Expósito <jose.exposito89 at gmail.com>
---
 drivers/gpu/drm/sti/sti_hdmi.c | 7 ++++---
 drivers/gpu/drm/sti/sti_hdmi.h | 2 --
 2 files changed, 4 insertions(+), 5 deletions(-)

diff --git a/drivers/gpu/drm/sti/sti_hdmi.c b/drivers/gpu/drm/sti/sti_hdmi.c
index f3ace11209dd..93841ba907a8 100644
--- a/drivers/gpu/drm/sti/sti_hdmi.c
+++ b/drivers/gpu/drm/sti/sti_hdmi.c
@@ -266,6 +266,7 @@ static void hdmi_active_area(struct sti_hdmi *hdmi)
 static void hdmi_config(struct sti_hdmi *hdmi)
 {
 	u32 conf;
+	struct drm_display_info *display = &hdmi->drm_connector->display_info;
 
 	DRM_DEBUG_DRIVER("\n");
 
@@ -274,7 +275,7 @@ static void hdmi_config(struct sti_hdmi *hdmi)
 
 	/* Select encryption type and the framing mode */
 	conf |= HDMI_CFG_ESS_NOT_OESS;
-	if (hdmi->hdmi_monitor)
+	if (display->is_hdmi)
 		conf |= HDMI_CFG_HDMI_NOT_DVI;
 
 	/* Set Hsync polarity */
@@ -984,9 +985,9 @@ static int sti_hdmi_connector_get_modes(struct drm_connector *connector)
 	if (!edid)
 		goto fail;
 
-	hdmi->hdmi_monitor = drm_detect_hdmi_monitor(edid);
 	DRM_DEBUG_KMS("%s : %dx%d cm\n",
-		      (hdmi->hdmi_monitor ? "hdmi monitor" : "dvi monitor"),
+		      (connector->display_info.is_hdmi ? "hdmi monitor" :
+							 "dvi monitor"),
 		      edid->width_cm, edid->height_cm);
 	cec_notifier_set_phys_addr_from_edid(hdmi->notifier, edid);
 
diff --git a/drivers/gpu/drm/sti/sti_hdmi.h b/drivers/gpu/drm/sti/sti_hdmi.h
index 05b2f3d0d48d..6d4c3f57bc46 100644
--- a/drivers/gpu/drm/sti/sti_hdmi.h
+++ b/drivers/gpu/drm/sti/sti_hdmi.h
@@ -57,7 +57,6 @@ struct hdmi_audio_params {
  * @reset: reset control of the hdmi phy
  * @ddc_adapt: i2c ddc adapter
  * @colorspace: current colorspace selected
- * @hdmi_monitor: true if HDMI monitor detected else DVI monitor assumed
  * @audio_pdev: ASoC hdmi-codec platform device
  * @audio: hdmi audio parameters.
  * @drm_connector: hdmi connector
@@ -83,7 +82,6 @@ struct sti_hdmi {
 	struct reset_control *reset;
 	struct i2c_adapter *ddc_adapt;
 	enum hdmi_colorspace colorspace;
-	bool hdmi_monitor;
 	struct platform_device *audio_pdev;
 	struct hdmi_audio_params audio;
 	struct drm_connector *drm_connector;
-- 
2.25.1




More information about the Linux-rockchip mailing list