[PATCH v7 9/9] arm64: dts: rockchip: Enable SFC for Odroid Go Advance

Chris Morgan macromorgan at hotmail.com
Thu Jun 10 20:38:54 PDT 2021


On Fri, Jun 11, 2021 at 10:26:35AM +0800, Jon Lin wrote:
> Hi Chris
> 
> May you attach the XT25F128B device code to me, and I'll try to work it out.

Sure, here is the patch I am using:

https://patchwork.ozlabs.org/project/linux-mtd/patch/SN6PR06MB5342C82F372F37FB8E21B327A57A9@SN6PR06MB5342.namprd06.prod.outlook.com/

> 
> On 6/11/21 1:36 AM, Chris Morgan wrote:
> > On Wed, Jun 09, 2021 at 10:13:48PM +0800, Jon Lin wrote:
> > > From: Chris Morgan <macromorgan at hotmail.com>
> > > 
> > > This enables the Rockchip Serial Flash Controller for the Odroid Go
> > > Advance. Note that while the attached SPI NOR flash and the controller
> > > both support quad read mode, only 2 of the required 4 pins are present.
> > > The rx and tx bus width is set to 2 for this reason.
> > > 
> > > Signed-off-by: Chris Morgan <macromorgan at hotmail.com>
> > > Signed-off-by: Jon Lin <jon.lin at rock-chips.com>
> > > ---
> > > 
> > > Changes in v7: None
> > > Changes in v6: None
> > > Changes in v5: None
> > > Changes in v4: None
> > > Changes in v3: None
> > > Changes in v2: None
> > > Changes in v1: None
> > > 
> > >   .../boot/dts/rockchip/rk3326-odroid-go2.dts      | 16 ++++++++++++++++
> > >   1 file changed, 16 insertions(+)
> > > 
> > > diff --git a/arch/arm64/boot/dts/rockchip/rk3326-odroid-go2.dts b/arch/arm64/boot/dts/rockchip/rk3326-odroid-go2.dts
> > > index 49c97f76df77..f78e11dd8447 100644
> > > --- a/arch/arm64/boot/dts/rockchip/rk3326-odroid-go2.dts
> > > +++ b/arch/arm64/boot/dts/rockchip/rk3326-odroid-go2.dts
> > > @@ -484,6 +484,22 @@
> > >   	status = "okay";
> > >   };
> > > +&sfc {
> > > +	pinctrl-0 = <&sfc_clk &sfc_cs0 &sfc_bus2>;
> > > +	pinctrl-names = "default";
> > > +	#address-cells = <1>;
> > > +	#size-cells = <0>;
> > > +	status = "okay";
> > > +
> > > +	flash at 0 {
> > > +		compatible = "jedec,spi-nor";
> > > +		reg = <0>;
> > > +		spi-max-frequency = <108000000>;
> > > +		spi-rx-bus-width = <2>;
> > > +		spi-tx-bus-width = <2>;
> > Note that I am still working with Jon Lin to research this, but it was
> > found in testing that if I set the tx bus width to 1 the problems I
> > encountered in earlier are resolved. At this time I do not know if it
> > is an issue with the driver for the flash controller, or if the NOR, or
> > board itself has some sort of errata which prevent dual tx from working
> > correctly. Note that as of right now the flash chip I am using (an
> > XTX XT25F128B) is not currently supported in mainline, so it's very
> > possible this is some sort of errata with the chip. It's also possible
> > that there is something with the board that is interferring with dual
> > mode TX.  When Jon comes back that he has tested dual mode on the SFC
> > with a different board/chip I will recommend that we change the tx
> > bus width here to a 1, and then once the XT25F128B gets mainlined we
> > can see if someone else has issues with dual tx mode so we can note
> > that as a problem with the chip. Or maybe there is something weird
> > with dual tx mode yet on the SFC driver/controller, I don't know yet.
> > I'm all too happy to work with a Rockchip engineer so things like
> > this can be determined before we hit mainline. :-)
> > 
> > The XTX25F128B driver is currently awaiting a decision on how to handle
> > continuation codes, as this chip ID should be using continuation codes,
> > but doesn't appear to return them when you query for manufacturer ID.
> > So I should also note in the commit here that the SFC will still be
> > unusable on the Odroid Go Advance until the XTX25F128B is also
> > mainlined.
> > 
> > Thank you.
> > 
> > > +	};
> > > +};
> > > +
> > >   &tsadc {
> > >   	status = "okay";
> > >   };
> > > -- 
> > > 2.17.1
> > > 
> > > 
> > > 
> > 
> > 
> 
> 



More information about the Linux-rockchip mailing list