[PATCH 7/9] arm64: dts: rockchip: adjust rk3568 pll clocks

[Heiko Stübner]

Hi Peter,

Am Mittwoch, 28. Juli 2021, 15:55:32 CEST schrieb Peter Geis:
> The rk3568 gpll should run at 1200mhz and the ppll should run at 200mhz.
> These are set incorrectly by the bootloader, so fix them here.

Can you specify where the "should run at" comes from?
Normally I'd assume setting desired PLL frequencies would be quite
board-specific.

So if we're setting defaults for all boards, I'd like some reasoning
behind that ;-) ... especially when the other option would be to
fix the bootloader.

Thanks
Heiko

> 
> Signed-off-by: Peter Geis <pgwipeout at gmail.com>
> ---
>  arch/arm64/boot/dts/rockchip/rk356x.dtsi | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/arch/arm64/boot/dts/rockchip/rk356x.dtsi b/arch/arm64/boot/dts/rockchip/rk356x.dtsi
> index 8ba0516eedd8..91ae3c541c1a 100644
> --- a/arch/arm64/boot/dts/rockchip/rk356x.dtsi
> +++ b/arch/arm64/boot/dts/rockchip/rk356x.dtsi
> @@ -230,6 +230,8 @@ cru: clock-controller at fdd20000 {
>  		rockchip,grf = <&grf>;
>  		#clock-cells = <1>;
>  		#reset-cells = <1>;
> +		assigned-clocks = <&cru PLL_GPLL>, <&pmucru PLL_PPLL>;
> +		assigned-clock-rates = <1200000000>, <200000000>;
>  	};
>  
>  	i2c0: i2c at fdd40000 {
>