[PATCH v12 01/10] dt-bindings: rockchip-sfc: Bindings for Rockchip serial flash controller
Jon Lin
jon.lin at rock-chips.com
Tue Jul 13 02:44:47 PDT 2021
From: Chris Morgan <macromorgan at hotmail.com>
Add bindings for the Rockchip serial flash controller. New device
specific parameter of rockchip,sfc-no-dma included in documentation.
Signed-off-by: Chris Morgan <macromorgan at hotmail.com>
Signed-off-by: Jon Lin <jon.lin at rock-chips.com>
---
Changes in v12:
- Remove useless oneOf lable
- Add sfc controller discription
Changes in v11: None
Changes in v10: None
Changes in v9: None
Changes in v8:
- Fix indent 4 to 2 in yaml
Changes in v7:
- Fix up the sclk_sfc parent error in rk3036
- Unify to "rockchip,sfc" compatible id because all the feature update
will have a new IP version, so the driver is used for the SFC IP in
all SoCs
- Change to use node "sfc" to name the SFC pinctrl group
- Add subnode reg property check
- Add rockchip_sfc_adjust_op_size to workaround in CMD + DUMMY case
- Limit max_iosize to 32KB
Changes in v6:
- Add support in device trees for rv1126(Declared in series 5 but not
submitted)
- Change to use "clk_sfc" "hclk_sfc" as clock lable, since it does not
affect interpretation and has been widely used
- Support sfc tx_dual, tx_quad(Declared in series 5 but not submitted)
- Simplify the code, such as remove "rockchip_sfc_register_all"(Declared
in series 5 but not submitted)
- Support SFC ver4 ver5(Declared in series 5 but not submitted)
- Add author Chris Morgan and Jon Lin to spi-rockchip-sfc.c
- Change to use devm_spi_alloc_master and spi_unregister_master
Changes in v5:
- Add support in device trees for rv1126
- Support sfc tx_dual, tx_quad
- Simplify the code, such as remove "rockchip_sfc_register_all"
- Support SFC ver4 ver5
Changes in v4:
- Changing patch back to an "RFC". An engineer from Rockchip
reached out to me to let me know they are working on this patch for
upstream, I am submitting this v4 for the community to see however
I expect Jon Lin (jon.lin at rock-chips.com) will submit new patches
soon and these are the ones we should pursue for mainlining. Jon's
patch series should include support for more hardware than this
series.
- Clean up documentation more and ensure it is correct per
make dt_binding_check.
- Add support in device trees for rk3036, rk3308, and rv1108.
- Add ahb clock (hclk_sfc) support for rk3036.
- Change rockchip_sfc_wait_fifo_ready() to use a switch statement.
- Change IRQ code to only mark IRQ as handled if it handles the
specific IRQ (DMA transfer finish) it is supposed to handle.
Changes in v3:
- Changed the name of the clocks to sfc/ahb (from clk-sfc/clk-hsfc).
- Changed the compatible string from rockchip,sfc to
rockchip,rk3036-sfc. A quick glance at the datasheets suggests this
driver should work for the PX30, RK180x, RK3036, RK312x, RK3308 and
RV1108 SoCs, and possibly more. However, I am currently only able
to test this on a PX30 (an RK3326). The technical reference manuals
appear to list the same registers for each device.
- Corrected devicetree documentation for formatting and to note these
changes.
- Replaced the maintainer with Heiko Stuebner and myself, as we will
take ownership of this going forward.
- Noted that the device (per the reference manual) supports 4 CS, but
I am only able to test a single CS (CS 0).
- Reordered patches to comply with upstream rules.
Changes in v2:
- Reimplemented driver using spi-mem subsystem.
- Removed power management code as I couldn't get it working properly.
- Added device tree bindings for Odroid Go Advance.
Changes in v1:
hanges made in this new series versus the v8 of the old series:
- Added function to read spi-rx-bus-width from device tree, in the
event that the SPI chip supports 4x mode but only has 2 pins
wired (such as the Odroid Go Advance).
- Changed device tree documentation from txt to yaml format.
- Made "reset" message a dev_dbg from a dev_info.
- Changed read and write fifo functions to remove redundant checks.
- Changed the write and read from relaxed to non-relaxed when
starting the DMA transfer or reading the DMA IRQ.
- Changed from dma_coerce_mask_and_coherent to just
dma_set_mask_and_coherent.
- Changed name of get_if_type to rockchip_sfc_get_if_type.
.../devicetree/bindings/spi/rockchip-sfc.yaml | 91 +++++++++++++++++++
1 file changed, 91 insertions(+)
create mode 100644 Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
diff --git a/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
new file mode 100644
index 000000000000..339fb39529f3
--- /dev/null
+++ b/Documentation/devicetree/bindings/spi/rockchip-sfc.yaml
@@ -0,0 +1,91 @@
+# SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
+%YAML 1.2
+---
+$id: http://devicetree.org/schemas/spi/rockchip-sfc.yaml#
+$schema: http://devicetree.org/meta-schemas/core.yaml#
+
+title: Rockchip Serial Flash Controller (SFC)
+
+maintainers:
+ - Heiko Stuebner <heiko at sntech.de>
+ - Chris Morgan <macromorgan at hotmail.com>
+
+allOf:
+ - $ref: spi-controller.yaml#
+
+properties:
+ compatible:
+ const: rockchip,sfc
+ description:
+ The rockchip sfc controller is a standalone IP with version register,
+ and the driver can handle all the feature difference inside the IP
+ depending on the version register.
+
+ reg:
+ maxItems: 1
+
+ interrupts:
+ maxItems: 1
+
+ clocks:
+ items:
+ - description: Bus Clock
+ - description: Module Clock
+
+ clock-names:
+ items:
+ - const: clk_sfc
+ - const: hclk_sfc
+
+ power-domains:
+ maxItems: 1
+
+ rockchip,sfc-no-dma:
+ description: Disable DMA and utilize FIFO mode only
+ type: boolean
+
+patternProperties:
+ "^flash@[0-3]$":
+ type: object
+ properties:
+ reg:
+ minimum: 0
+ maximum: 3
+
+required:
+ - compatible
+ - reg
+ - interrupts
+ - clocks
+ - clock-names
+
+unevaluatedProperties: false
+
+examples:
+ - |
+ #include <dt-bindings/clock/px30-cru.h>
+ #include <dt-bindings/interrupt-controller/arm-gic.h>
+ #include <dt-bindings/power/px30-power.h>
+
+ sfc: spi at ff3a0000 {
+ compatible = "rockchip,sfc";
+ reg = <0xff3a0000 0x4000>;
+ interrupts = <GIC_SPI 56 IRQ_TYPE_LEVEL_HIGH>;
+ clocks = <&cru SCLK_SFC>, <&cru HCLK_SFC>;
+ clock-names = "clk_sfc", "hclk_sfc";
+ pinctrl-0 = <&sfc_clk &sfc_cs &sfc_bus2>;
+ pinctrl-names = "default";
+ power-domains = <&power PX30_PD_MMC_NAND>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ flash at 0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <108000000>;
+ spi-rx-bus-width = <2>;
+ spi-tx-bus-width = <2>;
+ };
+ };
+
+...
--
2.17.1
More information about the Linux-rockchip
mailing list